SATPC0038528 Tab 04 4 SOW.pdf

STATEMENT OF WORK

Modular Steel Enclosure for Ames Research Center Thermal Protection System Branch Composites Oven Processing System

May 2025

National Aeronautics and Space Administration Ames Research Center Moffett Field, California

Modular Enclosure TSM Version: Rev 1

1.0 Background

NASA Ames is supporting various commercial and government entities in the fabrication, continued development, and integration of various Thermal Protection Systems (TPS) materials.

These parts will support Class-D missions, manufacturing surge mitigation, and small business (commercial space) requests for TPS materials.

2.0 Purpose and Scope

The purpose of this Statement of Work (SOW) is to procure Modular Steel Framed Cleanroom Structure around a large processing vacuum oven provided by Georgia Thermal Products.

3.0 Project Structure

The contractor shall provide all labor, materials, facilities, service, equipment, analysis, and management necessary to fabricate hardware defined in section 4.0.

4.0 Contract Line-Item Numbers

The effort described by this SOW shall be completed when all Contract Line Item Numbers (CLINS), defined in Table 1, are complete. Once the oven is delivered to the NASA facilities located at Moffett Field, CA, NASA requires additional services by vendor to assist commissioning the unit.

Table 1: Contract Line-Item Numbers (CLINS)

Line Item #

Part Qty. Delivery Date

1 Oven/Processing Area Enclosure 1 October 2025

5.0 Applicable Documents

The documents for this IAA include the following listed below:

Statement of Work (SOW) NF 1707 Form Independent Government Cost Estimate (IGCE) Quote from vendor Sole Source Justification

Modular Cleanroom Enclosure

6.0 Description of Tasks and Technical Requirements

6.1 Description of Tasks

Vendor is to fabricate quantity of parts specified in Table 1 per requirements specified in Section

6.2 of this document.

6.2 Technical Requirements

Technical requirements are documented below:

Vendor shall procure materials and fabricate on location at NASA Ames: Building N211 one modular steel frame cleanroom structure.

o Design, fabrication and install of Modular Steel Framed Cleanroom Structure Powder coated or Galvanized.

o 9’6” Wide x 25’ L x 9’6” High – with internal space for Waste Bay, Center Bay and Materials Bay

Ref. DRW: “In ROOM Equipment Layout_N-211_RevC_v1.4” o Structural calculations and drawings o Qty 4 cleanroom doors o Lift off panels

Waste Bay full width Work Bay partial width panels not to exceed 35 lbs 1/8” clear PVC roof o Work Bay lift of panels o Duct connections o 3/16” clear PVC Roof System o 3/16” PVC Wall System (Panel opacity per drw) o Access doors on each 2 short sides of Waste Bay o Onsite fitment verification around other equipment

7.0 Schedule

Table 2. Schedule for Deliverables Activity Responsible Start Date Delivery Date Fabrication and delivery of Parts in Table 1

Subcontractor June 2025 October 2025

8.0 Government-Furnished Property, Material, Equipment, or Information (GFP/M/E/I)

N/A

Modular Cleanroom Enclosure

9.0 Travel

No travel costs anticipated.

10.0 Period of Performance

The period of performance for this effort shall be from June 2025 to October 2025.

11.0 Point of Contact (P.O.C) Information

NASA Ames Point of Contact (POC):

NASA POC: Matthew Gasch | Thermal Protection Materials and Systems Branch Email: matthew.j.gasch@nasa.gov Office: (650) 604-5377 Address: Building 234 Room 211, NASA Ames Research Center, Moffett Field, CA 94035-

NSSC Contract Specialist:

Name:

Email:

Address: