RFQ_80NSSC18Q1364_Questions_and_Answers.pdf

Questions & Answers

1. What type of mounting will be needed?

The detector will be mounted to an aluminum 20”x20”X0.5” plate on an NSI XView system (See picture)

2. What orientation will the mounting need to be?

Need mounting holes onto the plate described above

3. What will the custom mounting interface to?

Mounting will interface to y axis rail as shown in picture

4. Will the mounting need to move if so what ranges/axis?

The mount will not need to move

5. Do you have a size requirement on the mount?

20X20X0.5in

6. How much additional shielding will be required? Size, thickness?

Need shielding for 450kV at the present time 0.5 Tungsten Shielding

7. Where do you need the additional shielding placed/mounted?

Need shielding in front of panel.

8. Do you have a drawing/sketch you can send to us?

Panel needs to be mounted on a 20X20X0.5in Al plate. I don’t currently have a specific drawing of exact hole locations and positions.

9. What panel are you currently using in this set up?

Varian 2520

10. Why can’t the current mount be used?

Varian panel currently attached to 20X20X0.5in plate

11. Are we removing the current unit or is that something you will take care of?

The Varian panel mounted on the 20X20X0.5in plate will be swapped out with the Perkin Elmer panel mounted on the 20X20X0.5in plate