7219 Advertisement to Bid_Reissue.pdf
PDF 183 KB Posted
- Attached to
- Sole Source - Oregon Kinship Navigator Program
- Solicitation number
- S-10000-00011481
- Issued by
- Wasco County, Oregon
About this file
This is an Advertisement for Bids issued by Clean Water Services (District) for the pre-purchase of equipment related to the Hillsboro Electrical Switchgear Project No. 7219. The District seeks bids for the supply and delivery of a new 480V Motor Control Center (MCC) and Switchgear system to replace existing equipment at the Hillsboro Water Resource Recovery Facility located at 770 S First Ave, Hillsboro, Oregon 97132. The equipment shall consist of a Main-Tie-Switch-Main lineup, three feeder MCC sections, two spare MCC sections, power monitors, and surge protection, with overall dimensions constrained to fit within existing limited space. The scope also includes commissioning and startup services comprising field inspections, certification of proper installation, and training of District personnel. Electronic bid submissions are required via Equity Hub's Bid Locker with a deadline of 2:00 p.m. local time on September 25, 2024, with public opening and reading by telephone conference at the same time and date. Bidders may coordinate site visits by contacting Leigh Kojiro at (503)-547-8185. Equipment delivery must occur by November 30, 2025, with substantial completion of services by May 15, 2026, and final completion by June 30, 2026. A single manufacturer shall be responsible for supplying all equipment with accessories and appurtenances, while the District will enter into a separate contract with an Installing Contractor for installation work.
The contract is not subject to Oregon prevailing wage requirements or federal Davis-Bacon Act requirements. All bidders must declare resident bidder status as defined in ORS 279A.120. The successful bidder must furnish a bond as prescribed in the Bidding Documents and will be responsible for coordinating with the Installing Contractor throughout the installation, startup, commissioning, and training phases. The District reserves the right to cancel the solicitation or reject any or all bids that do not comply with prescribed public bidding procedures, are from non-responsible bidders as defined in applicable purchasing rules and ORS 279A.010(1)(r), or when the District determines rejection is in the public interest. Bidders are responsible for monitoring the Bid Locker website daily for amendments, addenda, inquiry responses, cancellations, and award notices. Administrative inquiries should be directed to Michelle Mann, Procurement Specialist, at mannm@cleanwaterservices.org or 503-547-8035, while technical questions should be directed to Jonathan Lilly, Senior Electrical Engineer at R&W Engineering, Inc., at JLilly@RWEng.com or 503-726-3337.
View the file
Other files
| File | Type | Posted |
|---|---|---|
| S-10000-00011481 Sole Source.pdf |
On GovTribe
Work with this file
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
ADVERTISEMENT FOR BIDS
00030 - 2
SEPTEMBER 2024l
SECTION 00030
CLEAN WATER SERVICES
PRE-PURCHASE OF EQUIPMENT FOR THE HILLSBORO ELECTRICAL
SWITCHGEAR PROJECT NO. 7219 (REISSUE)
Clean Water Services (District) has determined it needs a new 480V Motor Control Center (MCC) and Switchgear to replace the existing switchgear at the Hillsboro Water Resource Recovery Facility, located at 770 S First Ave, Hillsboro, Oregon 97132 (Hillsboro WRRF). The new switchgear shall consist of a Main-Tie-Switch-Main lineup, three feeder MCC sections, and two spare MCC sections, including power monitors and surge protection.
This Invitation for Bids (ITB) is to request bids for the purchase of the following equipment and services:
Supply and deliver a new 480V MCC and Switchgear. The overall dimensions of the new MCC/Switchgear shall fit within the existing limited space as specified in the specifications included in this ITB (collectively, Goods). The selected contractor will also perform related commissioning and startup services consisting of commissioning and startup for the motor control centers and switchgear, field inspections, certifying proper installation, and training of District personnel (collectively, Special Services). A single manufacturer shall be responsible for supplying the described equipment with all accessories and appurtenances, including but not necessarily limited to, parameter setting software. District will enter into a separate contract with a contractor to install the Goods (Installing Contractor).
Interested Bidders must electronically submit bids to Michelle Mann, Procurement Specialist, via Equity Hub’s Bid Locker at https://bidlocker.us/details/4424 (Bid Locker) which will be accepted until 2:00:00 p.m. (local time), on September 25, 2024. Before Bidders can submit their Bids, they will need to register with Bid Locker at https://bidlocker.us/Home/bidlockerus. There is no cost to register. Late bids will not be accepted or considered. It is each Bidder’s responsibility, when submitting its Bid electronically via Bid Locker, to ensure timely delivery by submitting its Bid sufficiently in advance of the deadline. No paper, telephonic, email or facsimile bid submissions will be accepted.
Bids will be publicly opened and read aloud by telephone conference at 2:00 p.m. local time on September 25, 2024. Bidders can attend the opening by calling the telephone conference number 503.681-4499.
Goods must be delivered to the Hillsboro WRRF no later than November 30, 2025. The successful bidder will be responsible for coordinating with the Installing Contractor during installation, start-up, commissioning and training to ensure substantial completion of the Services by May 15, 2026 and final completion by June 30, 2026.
Bidders may download an electronic copy of the Bidding Documents and Bid Results from Bid Locker at https://bidlocker.us/details/4424. It is the Bidder’s responsibility to refer daily to Bid Locker’s website to check for any available amendments or addenda, responses to inquiries or questions, cancellations, or notices of intent to award, and any and all information regarding this opportunity. It is not District’s responsibility to notify participating Bidders by email or by any https://bidlocker.us/details/4424 https://bidlocker.us/Home/bidlockerus https://bidlocker.us/details/4424
00030 - 2
SEPTEMBER 2024l other means of any of the above. Copies of this advertisement can be obtained on the Bid Locker website or District’s website at https://dynamic.cleanwaterservices.org/Bids. If problems are experienced downloading the Bidding Documents, please contact Michelle Mann at 503.547.8035 or mannm@cleanwaterservices.org.
All bids must contain a statement as to whether the bidder is a resident bidder, as defined in ORS 279A.120. This Contract is not subject to Oregon prevailing wage requirements or federal Davis- Bacon Act requirements. The public contract to be awarded does not involve asbestos abatement work, and vendors bidding on this public contract are not required to be licensed with the Department of Environmental Quality pursuant to ORS 468A.720.
Any bidder desiring to view the site, should coordinate with Leigh Kojiro of District at (503)-547- 8185 or kojirol@cleanwaterservices.org. Site is located at 770 S. First Avenue, Hillsboro, OR 97123. The site is considered a construction zone and PPE including but not limited to hard hat, safety glasses, visibility vest, work shoes and pants are required.
For assistance with administrative issues, contact the Owner:
Clean Water Services Michelle Mann, Procurement Specialist 3235 SE River Road, Hillsboro, OR 97123 mannm@cleanwaterservices.org 503-547-8035
For assistance with technical issues, contact the Engineer:
R&W Engineering, Inc.
Jonathan Lilly, Senior Electrical Engineer 9615 SW Allen Blvd, Suite 107 Beaverton, OR 97005 JLilly@RWEng.com 503-726-3337
The successful Bidder will be required to furnish the Bond prescribed in Bidding Documents.
Owner reserves the right to cancel this solicitation or reject any or all Bid not in compliance with all prescribed public bidding procedures and requirements or when Owner finds that the Bidder is not responsible as that term is used in any applicable Owner’s Purchasing Rules and ORS 279A.010(1)(r). Owner may reject for good cause any or all Bids upon a finding by Owner that it is in the public interest to do so.
END OF SECTION
https://dynamic.cleanwaterservices.org/Bids mailto:mannm@cleanwaterservices.org mailto:kojirol@cleanwaterservices.org mailto:mannm@cleanwaterservices.org
File details come from the government source that posted it. Updated .