6127-7917 MOD.pdf

MATERIAL ORDERING DATA

SAE-AMS-QQ-S-763

IDN: N4523A 6127-7917

ICN: 88MSM00001 KO: 000 KOI: 000

Any specification that is referenced in the Material Order Data sheet is required to be to the latest revision at time of award.

Paragraph: 6.3 Ordering Data

a. SAE AMS-QQ-S-763D, Steel, Corrosion Resistant, Bars, Wire, Shapes and Forgings dated August 2013. Stabilized March 2015

AMS-QQ-S-763

document will no longer be updated and may no longer represent standard industry practice. This document was stabilized because this document is no longer state of the art and other documents contain similar but not necessarily equivalent requirements. Previously this document was active. The last technical update of the document occurred in August 2013. Users of this document should refer to the exceptions listed on the certification. NOTE: In many cases, the purchaser may represent a sub tier supplier and not the cognizant engineering organization.

b. Class: Class 304 Condition: Annealed (A), Form: Bar.

Finish* (Select one)

Hot Finished (Conditions A/T/H only, bar only): Bars in the hot-finished condition can be ordered with the following finishes :

Hot finished, scale not removed (excluding spot conditioning)

Pickled or blast cleaned and pickled

Rough turned (round bars only)

Cold Finished (bars only): Bars in the cold-finished condition can be ordered with the following finishes:

Cold drawn or cold rolled (Conditions A & B only)

Centerless ground or smooth turned (all conditions, round bars only)

Polished (all conditions, round bars only)

See Additional Data Requirements block.

*Wire is usually furnished with a cold drawn finish. Any exceptions must be specified in the purchase order.

c. Specify melting practice, if required: N/A

d. Specify other cleaning process, or indicate if cleaning is not required: REQUIRED

MATERIAL ORDERING DATA

SAE-AMS-QQ-S-763

e. Allowances for machining: N/A

f. Major stressed surface areas of the finished part: N/A

g. Whether low magnetic permeability is required for class 304 condition A, and the acceptable permeability values for classes other than 304 if such testing is desired: N/A

h. Whether exact or mill lengths are required: EXACT 10 FOOT LENGTHS ARE

REQUIRED.

i. Size and shape of forgings:

j. Whether continuous marking or other identification marking is required: REQUIRED PER

SEC. 3.10 OF THIS SPECIFICATION.

k. Other lot definition for forgings: N/A

l. Number of macrostructure samples required for special cases: N/A

m. Forging prolongations for testing: N/A

n. Whether retests are permitted: PERMITTED

o. Whether the material should be prepared for shipment by level A or C: C

p. Whether special marking for shipment is required: N/A

Additional Data Requirements:

CONTINUOUS IDENTIFICATION ~ ALL INDIVIDUAL LENGTHS MUST BE CLEARLY

MARKED PRIOR TO SHIPMENT. FOR QUALITY CONTROL PURPOSES, UNMARKED

MATERIAL WILL BE REJECTED UPON DELIVERY.

All unit intermediate and shipping containers must be marked in accordance with MIL-STD-

129. Refer to DLA Procurement Note C20 for further instructions.

Prepared By: Material and Technical Support

Code: 244.4