36C26319B0003-006.pdf

Installation Hotline • 866.EZINPRO

Inprocorp.com • 800.222.5556 • 262.679.9010

World Headquarters S80 W18766 Apollo Drive, Muskego, WI 53150 USA

Please read all instructions before installing wallguard.

IPC.379/REV.5

Installation Instructions Nu•Tree Wall Guard

SECTION VIEW

Safety Glasses, Tape Measure, Level, Power Drill, Drill Bits, Power Miter Saw, 1O” Blade with 60-80 Carbide Tipped Teeth

Recommended tools

Important

1. Acclimate materials 24 hrs before installation. Maintain temperature controlled environment after installation

2. Install in accordance with manufacturer’s installation instructions. Failure to do so will void the warranty.

WIDTH

HEIGHT

Nu-TREE

WALL GUARD

INSTALLER SUPPLIED

3/16" DIAMETER FLAT

HEAD FASTENER

NOTE: HEIGHT AND WIDTH

DEPENDENT ON PART

NUMBER. CHART SUPPLIED

ON NEXT PAGE

World Headquarters S80 W18766 Apollo Drive, Muskego, WI 53150 USA

Please read all instructions before installing wallguard.

COMPONENTS AND FASTENERS

Installation Instructions Nu•Tree Wall Guard

1 1/2" [38mm]

1 1/2" [38mm]

5 1/2" [140mm]

9 1/2" [241mm]

Part Number Width Height Length

NT-140 1/2" 8" 12'

NT-518 1" 5 1/2" 12'

NT-690 1 1/2" 5 1/2" 12'

NT-694 1 1/2" 7 1/2" 12'

NT-695 1 1/2" 9 1/2" 12'

World Headquarters S80 W18766 Apollo Drive, Muskego, WI 53150 USA

Please read all instructions before installing wallguard.

LAYOUT VIEW

EXPLODED ASSEMBLY

4" [102mm]

FIRST ANCHOR

EACH END

SPACE REMAINING

HOLES EVENLY

OVER 12' LENGTH

NOTE: TOTAL OF 6 ANCHORS

PER 12' LENGTH

Nu-TREE WALL GUARD

INSTALLER SUPPLIED

3/16" DIAMETER FLAT

HEAD FASTENER

Installation Instructions Nu•Tree Wall Guard

World Headquarters S80 W18766 Apollo Drive, Muskego, WI 53150 USA

Please read all instructions before installing wallguard.

Installation Instructions Nu•Tree Wall Guard

3/8" GAP FOR

EXPANSION

FIG. 1

FIG. 2

NU•TREE

WALL GUARD

TOTAL OF 6 ANCHORS

PER 12' LENGTH

DRILL 4"

FROM EACH END

FOR ANCHORS

SPACE REMAINING

HOLES EVENLY

OVER 12' LENGTH

INSTALLER SUPPLIED

3/16" DIAMETER

FLAT HEAD FASTENER

NU•TREE

WALL GUARD

FIG. 3

Please read all instructions before installing wall guard.

1. Cut wall guard to desired length. (Note: Trim factory edges square before installation). Select a 3/16" diameter, flat head fastener that is an appropriate length for the wall guard and substrate. Drill 3/16" holes on wall guard with a countersink to accommodate the fasteners. See Figure 1.

NOTE: For an exterior application, use stainless steel fasteners.

2. Position wall guard on wall at desired height. Level and mark holes. Drill marked holes on wall. Mount wall guard on wall and tighten screws to secure. Screw head can be covered with colored caulk. See Figure 2.

3. With lengths over 12', leave a 3/8" [10mm] gap between the aligned pieces of wall guard for expansion. See Figure 3.