36C25022Q0538_1.docx
DOCX document 15 KB Posted
- Attached to
- 7350--EQUIPMENT - Evidence Refrigerator - 583
- Solicitation number
- 36C25022Q0538
View the file
Other files
| File | Type | Posted |
|---|---|---|
| 36C25022Q0538.docx | DOCX document |
On GovTribe
Work with this file
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
Amendment to a Previous Combined Solicitation
Amendment to a Previous Combined Solicitation
| SUBJECT* |
| EQUIPMENT - Evidence Refrigerator - 583 |
GENERAL INFORMATION
| CONTRACTING OFFICE’S ZIP CODE* |
| 45409-1337 |
| SOLICITATION NUMBER* |
| 36C25022Q0538 |
| RESPONSE DATE/TIME/ZONE |
| 05-16-2022 12:00PM EASTERN TIME, NEW YORK, USA |
| ARCHIVE |
| 30 DAYS AFTER THE RESPONSE DATE |
| RECOVERY ACT FUNDS |
| N |
SET-ASIDE
| PRODUCT SERVICE CODE* |
| 7350 |
| NAICS CODE* |
| 332215 |
CONTRACTING OFFICE ADDRESS
Department of Veterans Affairs Dayton VA Medical Center 3140 Governor’s Place Blvd. Suite 210 Kettering OH 45409-1337
POINT OF CONTACT*
PLACE OF PERFORMANCE
ADDRESS
POSTAL CODE
COUNTRY
ADDITIONAL INFORMATION
AGENCY’S URL
URL DESCRIPTION
AGENCY CONTACT’S EMAIL ADDRESS
EMAIL DESCRIPTION
DESCRIPTION
The measurements for the table:
Worktable measures 26‐9" long x VARIES" wide x 36" high. The top is 14 gauge stainless steel with all four sides turned straight down 1‐1/2" and back 1/2" at 60 degrees from vertical. The base of the table is fully open and supported by 1‐5/8" O.D. x .065 thick stainless steel tubular legs fitted with stainless steel leg sockets and adjustable stainless steel bullet feet. The stainless steel shelf is continuously welded to the legs at approximately 10" off the finished floor with all four sides turned straight down 1‐1/2" and back 1/2" at 60 degrees from vertical.
Table to have 3 sinks, lever drain, small scrap basket, 12” back splash, 2 extra shelves on far right end, and marine edge, splash mount faucet and pre‐rinse.
The install shall include:
GILL MARKETING Model No. INSTALL Gill Marketing (GM) will install “L” shaped three compartment sink and table to include the following:
GM will disconnect plumbing from existing table.
GM will remove existing sink and table and move to loading dock to remain Government property.
GM will uncrate and set in place new “L” shaped sink.
GM will weld and polish one seam.
GM will install faucet and pre‐rinse spray units.
GM will make final utility connections to existing plumbing at terminating point on the same floor level.
VAMC to dispose of existing unit.
VAMC to verify proper sized utilities at terminating points on the same floor level.
| *= Required Field |
| Amendment to a Previous Combined Solicitation |
Page 1 of
Amendment to a Previous Combined Solicitation
File details come from the government source that posted it. Updated .