36C24719Q0324-0002004.pdf

SAFETY AND GOVERNOR TEST

Building Name _RALPH H. JOHNSON MEDICAL CENTER Date: June 10, 2018 Address 109 BEE STREET City CHARLESTON _______ St _SC_ Zip 29401 Elevator Serial # _9109_____Building Elevator # ___P5__State ID #____N/A_____ Elev Make:__OTIS____________ Job # __02-5906__________ Safety Mfg ______OTIS____________ Governor Mfg HOLISTER WHITNEY____ Type Governor:

Fly Ball ____________________ Flyweight ____YES_______________Cable Condition _____GOOD___________ Governor Cable: Iron _______________ Steel ____YES__________ 8 X 19 ______YES______ 6 X 19 ______________ Size (diameter) ______3/8”________.

Jaws Type:

Steel __YES_________ Bronze _____________ Jaws Condition _________GOOD_____________________ Type of Safety:

Instant roll _______________ Wedge Clamp ______________ Flex Guide ____YES________ Other ___________ Condition ____GOOD_________________________________________________________________________ ContactsOn:

Governor _____YES_______________ Releasing Carrier _____________________ Safety ______YES_________ Rated: Car Capacity ___4000__________ Safety ______________________ Car Speed ______250_________FPM Governor Trip Speed ____337________FPM. Safety Drum Rope condition _______N/A________ Size ___________

NOTE: REMOVE ELEVATOR FROM PUBLIC USE

1) Inspect governor, ropes and safety to insure equipment is free of excess lubrication and dirt.

Yes X__ No __.

2) Inspect governor, ropes and safety to insure all equipment is in place, and as designed.

Yes X___ No __.

3) With out car moving and power off, operate the governor and safety device by hand to insure all bearings and rubbing surfaces operate freely.

Yes X___ No __.

4) Wedge clamp safety, Power Off:

Operate governor rope by hand. Length of pull-out off drum _________. Turns left on drum ______ (At least three (3) required). Reset Safety. NOTE: 200 fpm = 42”, 200+ fpm = 36”, 375+ fpm = 30”.

5) Governor:

With variable speed motor, test:

Switch tripping speed ____305___________ fpm.

Jaws tripping speed _____340___________ fpm.

New setting-switch _____SAME____________ fpm.

New setting - jaws _____SAME____________ fpm.

Final test-satisfactory: Yes __X ____ No _______.

6) No Load Test: “Low Speed”.

Operate car at low speed in the down direction, trip governor by hand and set safety device completely.

Did car stop level? Yes __X ___ No _______. (see #13) Is rope pull out satisfactory? Yes __X____ No ________.

Check rails for damage. Yes __X ______ No _________.

7) No Load Test: “High Speed”.

Operate car at high speed in the down direction, trip governor by hand and set safety device completely.

Did car stop level? Yes ___X ____ No _________.

Is rope pullout satisfactory? Yes ___X____ No __________.

Check rails for damage.

Reset Governor and safety and check operation. Yes ___X ______ No __________.

8) Add rated capacity test weights to car. Operate car and observe the acceleration, slowdown, leveling and stop in both directions. Note operation of the brake. Perform an emergency-stop in both directions and monitor brake performance. Yes ___X_ _____ No __________.

TEST RESULTS: __________PASSED _______________________