FAQ_for_140G0322Q0030_0001.pdf

FAQ for 140G0322Q0030

12/13/2021

Question 1: Are we able to just bid on the Enclosures?

Answer 1: Yes, you may provide a quote only on the enclosures.

Question 2: Are all 50 units needed by 3/1? Is that date flexible or are staggered deliveries acceptable?

Answer 2: Yes, staggering the deliveries is acceptable.

12/14/2021

Question 3: Can they eliminate galvanizing the steel?

Answer 3: No.

12/15/2021

Question 4: Is it possible to propose a direct ship quote?

Answer 4: Yes, please propose a shipping charge.

12/20/2021

Question 5: What is the required alloy of aluminum for fabrication of the equipment boxes?

Answer 5: We didn't specify down to this level. We are looking for the best corrosion resistant alloy, which may be 1xx.x, we are not metallurgists though, so this was a spec we did not anticipate.

Question 6: Do I get a freight quote from only Fed Ex? Then at the time of shipment I contact you and use your Fed Ex account and adjust the delivery charge?

Answer 6: The delivery charge will be paid for using our FedEx account number. Please provide an estimate of shipping as a separate item.

12/22/2021

Question 7: Concerning the 9’ Mast on the diagram mentioned request#. The 3” sch 40 pipe with the OD 3 -3/8”. There is 3-1/2” OD but not 3-3/8” OD.

Do you want this whole structure hot dipped galvanized with Powder coat on top of the Hot

Dipped Galvanizing? Would you consider having them made using Stainless Steel?

Answer 7: We don’t want stainless for the boxes, understand on the OD dimensions, and my understanding is that for a powder coat to work on galvanized it should be hot dipped.

Josh B Arrow

Josh B Typewriter

Will there be a gasket on this surface if so what type and thickness? (yes, but a gasket should actually be under the lid in the same area, rubberized foam gasket 1/2 inch thick same width as top of non-lid box lip.).

Josh B Arrow

Josh B Arrow

Josh B Typewriter Clarification on hole pattern and location

1. Is the hole qty. Correct both sides? yes

2. Are the holes 1" to center on both edges of the plate? 1 inch from side of plate, 1.5 inches from top and bottom of plate.

Josh B Arrow

Josh B Arrow

Josh B Typewriter Bend Length (2 inches long)

Josh B Arrow

Josh B Arrow

Josh B Typewriter Hole Locations?

Centered,m 2.5 inches from top,

2.5 inches from side

Josh B Arrow

Josh B Typewriter Required overall thread length? 2 inches

Josh B Arrow

Josh B Typewriter Do you have a certain type of galvanize you want to use? Hot Dipped for best results on powder coating.

Josh B Arrow

Josh B Typewriter Is the brand required? yes