REVISED_STATEMENT_OF_WORK_0001.pdf

The U.S. Fish & Wildlife Service, FWS Klamath Basin NWR Complex has a requirement for 110,000 LB Goose Neck Lowboy Trailer for delivery to Lower Klamath Shop at 10242 Stateline Road, Tulelake, CA 96134-9758 in accordance with the following REVISED STATEMENT

OF WORK:

REVISED STATEMENT OF WORK

Minimum requirements for the gooseneck lowboy trailer:

• Capacity: 110,000lbs

• Overall Length: 53 feet maximum

• Gooseneck length approximately 12-foot 11-inches.

• 110-inch gooseneck swing to accommodate pontoon length.

• Main Deck Length: 25 feet

• 102-inch deck width

• Mainframe to be made out of T1 steel

• 24-inch loaded main deck height

• 8-inch ground clearance

• Hydraulic self-lifting detachable gooseneck (non-ground bearing) self-contained with pony motor. Must be compatible with our current transport truck.

• Full depth boom trough area in wheel area.

• Load bearing removable wheel covers.

• 2-inch Apitong or oak decking.

• Swing out outriggers.

• Outrigger planks

• Tie downs: Minimum of five (5) each side of deck. Minimum of one (1) each side of gooseneck. Minimum of two (2) each side of tail. Minimum of two (2) rear of tail.

• Third axle airlift.

• 60-inch axle spacing.

• 25,000 pound axles.

• Fixed approach ramps, no flip.

• Flasher kit switched and mounted.

(LOWBOY TRAILER MUST BE ABLE TO MEET THE SPECIFICATIONS

NECESSARY TO HAUL SAID EXCAVATOR LEGALLY AND SAFELY ACCORDING

TO DOT STANDARDS IN CALIFORNIA AND OREGON. SEE EXCAVATOR

SPECIFICATIONS BELOW):

Delivery Requirements:

Completed trailer to be delivered to the FWS Klamath Basin NWR Complex, Lower Klamath Shop at 10242 Stateline Road, Tulelake, CA 96134-9758, on or before August 31, 2023.Delivery can be made Monday through Thursday, 6:00 AM to 3:00 PM local time. Please contact the Technical Point of Contact (POC), Steve Huhnke at (steve_huhnek@fws.gov/541-891-7104, 24 hours prior to delivery.

Inspection and Acceptance: The Refuge EEO Supervisor and/or designated refuge staff will determine evaluation and acceptance.

Technical Point of Contact:

Steve Huhnke, Engineering Equipment Operator Supervisor Email: steve_huhnke@fws.gov Phone: (541) 891-7104

Alternate POC:

Ken Griggs, Deputy Project Leader Email: Kenneth_griggs@fws.gov Phone: (530) 667-8301 mailto:steve_huhnek@fws.gov/541-891-7104 mailto:steve_huhnke@fws.gov mailto:Kenneth_griggs@fws.gov