Attachment_2-_Electronic_Monitoring_Equipment_Specifications.pdf

Attachment 2-Electronic Monitoring (EM) Specifications

Functional Requirements An EM system consists of two major elements; hardware and software. The proposed specifications are based on the general EM program objectives included above for a catch share monitoring program.

Incorporating more defined objectives (i.e., data timelines or turnaround, volumetric measurements, etc.)

may negate or alter some of the specifications listed below. The standards below are set as minimum requirements, as advancements in technology improve these standards may be amended.

Hardware I. General

• Hardware should be adaptable and transferrable in application to enable deployment on a variety of fishing vessels (size, gear, target species).

• Hardware should be easily maintained by the vessel crew and spare parts readily available in close proximity to the vessel port.

• Hardware, including but not limited to wires, cameras, control box, and sensors, should be adequately shielded to prevent radio frequency interference (RFI) with Vessel Monitoring System (VMS) units. All vessel electronics need to work together simultaneously.

• The EM system should be compatible with NMFS approved VMS units (http://www.nmfs.noaa.gov/ole/docs/2015/040815_noaa_fisheries_service_type.pdf).

II. Power

• Ability to run off DC or AC power supply, inverters, or generators.

o Power draw should be minimal (with 8 digital cameras, a maximum of 120 watts).

o Power wires should be resistant to damage, water, weather, sun, etc.

o Provide safeguards to retain data in the event of electrical failure or power spikes.

o Vessels interested in using EM should note the power requirements of the system.

Necessary improvements to a vessel needed to accommodate EM will be borne by the vessel owner.

III. Vessel Data Storage

• The system should have sufficient data storage capacity to store all video and sensor data for an entire month (minimum of 500 gigabytes storage capacity). Each frame of stored image data should record a time/date stamp in (format yet to be determined).

o Data storage hardware should be resistant to damage and data loss.

• The system must include a means of removing data from the EM unit, such as;

o At least two external USB ports, o Removable storage device (e.g., hard drive) approved by NMFS or, o Other approved means of transferring data approved by NMFS.

IV. Cameras and Review

• Cameras (number of cameras will vary by vessel and program needs) should be enclosed in a waterproof armored-dome. Cameras should have a minimum IP rating of 66.

• Cameras should be capable of point-to-point or point-to-multipoint transmission (not openly transmitted) on all monitors.

• All cameras within a system should operate in synchronization for review and analyses purposes.

Synchronized playback should occur with a 10 second timeframe.

• Cameras should be capable of operating continuously to meet data needs.

• Each camera should be easily surface mounted on vessels and provide manually adjustable viewing positions.

• Each camera should be compatible with a range of fixed focal length lenses to enable swapping of lenses or have varifocal lenses to achieve monitoring goals.

RFQ 1305M218QNFFM0043

• Cameras must provide the option to produce still images for enhanced species identification and measurement.

• Cameras must be able to be triggered to record fishing, catch handling, transiting or any other vessel activity.

• Camera resolution must be a minimum of 1,280 x 720 (720p) for enhanced identification and measurement during video review. Resolution must be sufficient to discern individual fish (detect, count, and identify to species level) from distance. NMFS strongly encourages the use of higher resolutions than those described above whenever possible.

• Cameras must record at a speed of no less than 15 unique frames per second when the use of a video monitoring system is required.

• Some manufacturers use proprietary compression formats that require the use of proprietary software in order to view the video sequence or images. Use of such software can prevent or hinder law enforcement from viewing or otherwise accessing these images. If such software is used, then steps must be taken to ensure that law enforcement will be able to access them when needed.

• Cameras must have sufficient fields of view to observe all areas where fish could be sorted, processed, and discarded.

• Cameras must have auto-iris capabilities and produce color footage with the ability to revert to black and white video output when light levels become too low for color recognition.

o Cameras must be capable of functioning during low light conditions to account for nighttime fishing activity. “Functioning” is defined as allowing video reviewers to count, identify, and measure individual fish and otherwise account for fishing activity and catch handling.

• Monitors should be appropriate to the vessel size and power supply, such that the monitor size is sufficient for the captain and EM technician to access and evaluate the EM system performance before, during, and after a fishing trip. Power draw by the monitor should be such that it will not overburden the vessel's power supply. The video monitor must:

o Display all cameras simultaneously;

o Operate at all times, including when fish are handled or sorted; and o Be securely mounted and readily accessible to the EM technician and captain and crew.

• If required, measurement grids (discard chute, sorting table panel, etc.) should be designed and tailored to each gear type and vessel size and compatible with common species caught by the vessel.

• Measurement grids should be capable of calibration (through the EM software) to ensure data accuracy and precision.

o Discard chutes should have a continuous flow of water across their surface at a speed which is conducive to identification, counting, and measurement of catch.

o Grids should be constructed of a material that allows catch to flow smoothly, without snagging.

o Grids should be fixed in place during fishing activity and be resilient to standard vessel motions.

o Grids should be of an appropriate size and shape and not impede or hamper normal fishing practices.

• All components (including cameras, sensors, control box, and wiring) of a robust system must be capable of starting up and functioning during extreme weather conditions (temperatures in the Northeast range from -7 to 29 degrees Celsius) wherever and whenever groundfish vessels are actively fishing. The Northeast groundfish fleet includes a number of small boats with semi-enclosed wheelhouses. Spray, condensation, cold, and heat occasionally enter the wheelhouse on these vessels. Weather conditions include:

o Extreme heat, freezing rain/spray, ice, snow, fog, and hail.

o Waves ranging from spray inducing chop to damaging large waves.

o Violent pitching or listing.

V. Sensors

• The system must include a minimum of at least two sensors to trigger camera recording (one main sensor may be used to trigger recording but a second sensor is required as a back-up in case the primary sensor fails).

o Sensors may include a hydraulic sensor, drum sensor, motion triggered sensors, or other means of triggering cameras (must be approved by NMFS).

o Sensors must be compatible with standard vessel equipment.

• The system must include an independent GPS unit (separate from the vessel’s own GPS) to produce track of vessel transit and fishing activity.

VI. Preferred Features

• The system should have electronic reporting capabilities and the option to link with eVTR software.

• Hard drives should be durable drives that are able to withstand postal mailing.

• Hard drives should be pre-formatted for ease of use and to allow the captain to exchange hard drives readily.

• Regular system upgrades as technology advances.

Software I. EM Data Review

• The software must include basic video and navigation functions (at a minimum: record, start, stop, bookmarking, play, synchronized playback, standard viewing capabilities copy and save functions, etc.).The system must output video files to an open source format or, if custom or licensed-based software is used, access to data must be supplied (server, licenses, etc.) to the government for data processing purposes throughout the duration of program.

• Software should include the ability to accomplish the below functions;

o Assess video quality based on standard requirements including but not limited to;

complete sensor data (if applicable), camera functionality, presence of video gaps (missing or incomplete), clarity of images (are cameras dirty, focused, covered by salt spray, etc.), sufficient camera angle to monitor catch, species identification, and sufficient view of catch handling practices, etc.

o Allow reviewers to identify each species caught or at minimum store images of unknown species for later identification and inclusion in the catch record.

II. Security

• Data encryption or tamper evident features (video and sensor).

• Software must be secure, have the ability to lock and protect data, and detect if the EM system was tampered with at any point during a fishing trip (tamper evident).

III. Compatibility

• Software must be compatible with:

o Personal Computers (PC);

o Windows-based operating systems; and o Internet Explorer and other commonly used browsers.

• Software must produce data in a file format such as .xls, or .xml that is compatible with an Oracle database.

• The system must use commercially available software or provide proprietary licenses.

IV. Pre-trip System Check

• Software must include a pre-trip assessment of the EM system to indicate all components are functional prior to trip start.

V. Data Validation

• Software must include the ability to verify a complete trip (complete EM trip is defined as a trip where video was recording 100% of the time, trip start to trip end).

• Software should record and utilize the following data fields;

o Vessel permit number, vessel name, VTR serial number/trip ID, gear type, targeted species, sail date and time, land date, trip type, number of hauls/tows, statistical area fished, fish species (kept and discarded), disposition (kept or discarded), and an estimated weight by species.

o Software shall include identifying timestamps, location, vessel name/number, and a GPS unit to facilitate review.

o Software shall utilize timestamp and sensor data to determine number of hauls and haul begin time for the trip (video data may be used to verify haul begin time).

• Sensor data shall display vessel track, fishing start/end locations and times, transit locations and times, and provide a complete record of all fishing activity during a given trip.

o Sensor data shall display data from the GPS as well as power to the EM system, and sensors used to trigger recording.

VI. Shoreside Data Storage

• System data and video footage should be stored by the provider for 3 years after collection and must include sufficient data backup features to protect data.

VII. Data Output

• Initial review results (preliminary data) should be made available to sector managers to facilitate weekly sector reporting timelines.

o JPEG, video, sensor, and statistical data review methods should conform to this standard.

• Statistical data output shall be organized in such a way as to lend itself to comparison to still images and/or video data.

VIII. Preferred Features

• Automated species ID, automated measurement, and automated weight estimate.

o Software should be able to incorporate additional species for automated processing.

o Able to handle automated ID of multiple fish at a time (i.e. not single file fish fed down a chute), multiple fish orientations, weather conditions, light conditions, etc.

• Remote transmission of EM data within 24 hours of vessel landing.

• Software must be easily modified to incorporate regional preferences.

• The system should be portable between platforms (fishing vessels) where peripherals (cameras, sensors) are static and core components (computer, software, discard chute) are transferred.

• The system should have electronic reporting capabilities and the option to link with eVTR software.

• Preference for data output in a JSON (JavaScript Object Notation) open-standard format.