Attach 02 - Specs Fire Command Package Build - EN 4069.pdf

RFQ No.: 12034320Q0010 / Utility Service Body & Fire Command Package Build - EN 4069 / IPNF Attachment 02 – Specs for Fire Command Package EN 4069

TECHNICAL SPECIIFICATIONS FOR FIRE COMMAND VEHICLE

2019 Ford F350 Cab and Chassis Vehicle Number 4069

LIGHT BAR

The light bar will be 54”, centered from front windshield to back of cab, mounted with the use of appropriate mounting brackets sized to fit the vehicle being outfitted.

Lighting be a Whelen Liberty II or equivalent and will consist of low profile, light emitting diode (LED).

Lenses will be clear with internal LED or strobe lighting illuminating the corresponding color as described in the specifications and lighting schematic sheet.

The lighting schematic will be set as follows:

• Two (2) forward facing white takedown modules in the two center positions.

• Two (2) Alley lights mounted one on each end.

• Two (2) forward facing, steady red modules, one outboard of each takedown light

• Two (2) forward facing. flashing red modules, one outboard of each steady red module

• Four (4) corner position red flashing modules.

• A traffic advisor shall be installed into the rear facing portion of the light bar. The traffic advisor shall consist of six (6) amber lamps.

RFQ No.: 12034320Q0010 / Fire Command Package & Utility Bed - EN 4069 / IPNF

SIREN SPEAKER

Siren speakers will be compact and a minimum of 100 watts.

Recommended speaker:

Whelen Compact Federal Signal Gall’s 100 Watt Part No. SA315P Dynamax Concealment Part No. ES100 Part No. SK145

Mounting brackets and locations will vary due to make and model of vehicles.

CONTROL HEAD

The control head must be Smart Siren Platinum Controller. Model Number SSP3000B or SSP2000B

Installation of control head shall include wiring existing Forest Service Bendix King radio into the control module to enable PA and Radio broadcasting.

The position control will be wired as follows

• Pos. 1 Light bar

• Pos. 2 Light bar + grille lights + rear lights + side lights

• Pos. 3 Light bar + grille lights + rear lights + sidle lights + flashing alley + takedown lights + Siren

Push button functions will be set as follows:

• 1 Left alley

• 2 Right alley

• 3 Take down lights

• 4 Left amber traffic advisory

• 5 Right amber traffic advisory

• 6 All amber traffic advisory lights

• All other push button functions reserved for future use

CENTER CONSOLE

Center console will be sloped from the front to the back (see picture) and type which installs between the driver and passenger seats and is secured to the floor of the vehicle. Wide Body w/ Open Storage 20″ Center console or closed storage box on the rear of center console that will be capable of mounting the following items. Any removed items/equipment will be returned to the government

Radio’s and Siren Control head will be installed in the following order from top to back.

• Forest Service supplied C.B Radio and antenna installed.

• Forest Service supplied mobile King radio and antenna.

• Forest Service supplied mobile VHF radio and antenna.

• Siren/light control head

• All antennas and Cell phone booster antenna will be installed on front top of utility bed. No holes are to be drilled in the roof of the truck for the installation of antennas.

• (2) Top mounted cup holders in the rear most top position.

• (3) USB charging port wired

• (3) plug in cigarette type receptacle located on the front most top position wired

• (1) Flexible, “goose-neck” task LED light, 18” length with on/off switch and dimmer control. installed on Passenger side of Console towards the top

• (1) adjustable armrest for driver side

• (1) Fuse Panel for wiring additional items 12 volt, installed inside console.

• Power switch for console to be installed on side of console on drivers side

• Charge guard with auto shutoff set to one hour.

• Connect existing vehicle radio USB to console if not already connect, vehicles arrived from factory without original center console and this may need to be reconnect to allow the use of the USB with cell phones.

• Radio Chargers for King Handheld Radio, Forest Service supplied

• Cell Phone booster, installed inside center console, Forest Service Supplied

GRILLE LIGHTS

Slim profile LED lights will be installed on the vehicles. Two individual LED light heads consisting of a red and white will be used.

Whelen ION Series Super-LED Universal Light s or equivalent will be installed. The two lights will be installed near the center of the grille. Driver side light will be a red LED and passenger side light will be a white LED. Please note: The accompanying pictures show dual colors in a single light, the lights required are a single color per light.

CORNER LIGHTS

Conflicts with certain Dodge and Chevrolet vehicles onboard computer systems occur when using a headlight flasher such as the UHF2150A. Use of headlight flashers will not be used.

Four compact LED corner lights will be installed in each vehicle. Two will be white, one in each in the front head light assembly or within an enclosed bezel and two will be red, one each in the rear taillight assemblies.

Whelen Vertex Competitor Series Super-LED or equivalent will be used.

SIDE LIGHTS

Two compact red LED side light will be installed in each vehicle, one on drive side and one on the passenger side front quarter panel.

Whelen ION Mini T-Series Linear –LED optics or equivalent will be used.

Vehicle Striping

Reflective Forest Service Decal Kit: Reference attached document for striping standards.