02481F00-F06 SALIENT CHARACTERISTICS.pdf

Salient Characteristics for a Laser Scanner

Project #031-021

14 Aug 20

1. One (1) Artec Leo 3D Scanner, Rapid Scan 3D, with one (1) battery, Item # Leo.

2. Two (2) Artec Batteries for Leo, Item # Leo Battery

3. One (1) License of Artec Studio Software Subscription Model (good for 5 Years), Item # AS_1_S(5).

4. One (1) Artec Digital Manual with software download, Item # MISC

5. One (1) 3rd Year Warranty & Support (for a total of three years of warranty and support) for Artec

Leo, Item # W&S Leo. The warranty period shall be for a total of three years. Supplies and services furnished shall be covered by warranty from defects in design, materials and workmanship. The warranty shall be the manufacturer’s standard commercial warranty, which shall conform to all the requirements of the contract. Acceptance of the manufacturer’s standard commercial warranty shall not minimize the rights of the government under clauses in the contract, and in any conflict that arises between the terms and conditions of the contract and manufacturer’s warranty, the terms and conditions of the contract shall take precedence. The warranty period shall commence from the date of acceptance. All warranty work shall be provided by a factory authorized distributer.

6. One (1) Artec Leo Battery Charger, Item # Battery Charger Leo

7. Transformer (For The Battery Charging System) NRTL Certification Report - This includes the transformer (for the battery charging system) and its component parts shall be in compliance with applicable Code of Electrical Regulations (CFR) Title 29, Part 1910. By definition, any equipment will be deemed acceptable and approved by TRF, Bangor, if it meets specific Occupational Safety and Health

Administration (OSHA) conditions outlined in CFR Title 29, Part 1910; Subparts "O" and "S".

Specifically, equipment will be "Accepted" by TRF, Bangor, if it has been inspected and found by a

Nationally Recognized Testing Laboratory (NRTL) to conform to specified plans or procedures of applicable codes. The equipment (as a whole system) shall be Nationally Recognized Testing Laboratory

(NRTL) inspected and certified (by an OSHA authorized third party). One (1) “hard” copy of the NRTL certification report shall be provided. If the equipment type/model has already been NRTL inspected and certified, a certification report (one (1) ”hard” copy) or documentation mounted on the equipment, (which acknowledges it is NRTL certified), shall be provided.

8. Asbestos – No asbestos products/materials/shall be used in any components (i.e. gaskets, etc.) of the equipment. The equipment shall be asbestos free.