"" title: title: 31 inch mach 10 survey rake 1.0 introduction this statement of work (SOW) describes the fabrication of the 31INCH mach 10 survey rake. The new 31INCH mach 10 survey rake will be…

"" title: title: 31 inch mach 10 survey rake 1.0 introduction this statement of work (SOW) describes the fabrication of the 31INCH mach 10 survey rake. The new 31INCH mach 10 survey rake will be tested in NASA langley s 31 inch mach 10 tunnel. 1.1 scope the contractor shall provide manufacturing review, fabrication and materials for the 31INCH mach 10 survey rake as outlined below. The designation for this model hardware is D214-14-0005. 1.2 general description the contractor shall complete the fabrication of the 31INCH mach 10 survey rake per the provided drawings and electronic files. 2.0 information provided included with this statement of work are the following: a) drawing 1273017 (reference only) b) drawing 1273018 (reference only) c) drawing 1273019 d) drawing 1273020 (reference only) e) drawing 1273021 f) drawing 1273022 g) drawing 1273023 h) drawing 1273024 (reference only) i) drawing 1273025 j) drawing 1273027 (reference only) k) drawing 1273082 (reference only) l) electronic files 3.0 model fabrication requirements (as per drawings when applicable, otherwise as defined) 3.1 fabrication the contractor shall fabricate the 31INCH mach 10 survey rake in accordance with all sections of this statement of work and supplied contract drawings and files. The contractor shall fabricate the 31INCH mach 10 survey rake hardware per drawings 1273019,1273021,1273022,1273023 and 1273025. Plastic parts per drawings 1273024 and 1273027 shall be furnished and installed by the government. Turntable modifications per drawing 1273018 shall be performed by the government. Short strut per drawing 1273082 shall be government furnished. Probe assembly and brazing per drawing 1273025 shall be performed by the government (the contractor shall be required to manufacture the hardware). 3.2 materials the contractor shall provide the materials to fabricate the 31INCH mach 10 survey rake in accordance with all sections of this statement of work and supplied contract drawings and files. 3.3 identification applicable drawing numbers shall be permanently marked on each part in an area that is not in an internal or external flow or on a sealing surface. 3.4 structural welding the contractor shall perform any structural welding that is a result of a design requirement in accordance with LPR 1710.15, section 2.5, or the welding code or specification designated by the larc technical project engineer (TPE)/ research project engineer (RPE). All welding shall be qualified to the applicable code. Pre-qualified procedures are not accepted at larc. The NASA larc quality assurance certified welding inspector shall review the contractor s drawings and submittals. The contractor shall provide documentation to show that all welding efforts are done in accordance with the applicable sections of these specifications. The contractor shall submit one (1) copy of the welding procedure and qualification documents, to include the procedure qualification record (PQR), welding procedure specification (WPS), welder qualification record (WQR) as required by asme boiler & pressure vessel code, section IX, for review ten (10) working days prior to start of any welding.