"" other functions: title: 31 inch mach 10 short strut 1.0 introduction this statement of work (SOW) describes the fabrication of the 31INCH mach 10 short strut. The new 31INCH mach 10 short strut…

"" other functions: title: 31 inch mach 10 short strut 1.0 introduction this statement of work (SOW) describes the fabrication of the 31INCH mach 10 short strut. The new 31INCH mach 10 short strut will be tested in NASA langley s 31 inch mach 10 tunnel. 1.1 scope the contractor shall provide manufacturing review, fabrication and materials for the 31INCH mach 10 short strut as outlined below. The designation for this model hardware is D214-14-0004. 1.2 general description the contractor shall complete the fabrication of the 31INCH mach 10 short strut per the provided drawings and electronic files. 2.0 information provided included with this statement of work are the following: a) drawing 1273020 b) drawing 1273082 c) drawing 1158983 d) drawing 1158984 e) drawing 1158985 f) electronic files 3.0 model fabrication requirements (as per drawings when applicable, otherwise as defined) 3.1 fabrication the contractor shall fabricate the 31INCH mach 10 short strut in accordance with all sections of this statement of work and supplied contract drawings and files. 3.2 materials the contractor shall provide the materials to fabricate the 31INCH mach 10 short strut in accordance with all sections of this statement of work and supplied contract drawings and files. 3.3 identification applicable drawing numbers shall be permanently marked on each part in an area that is not in an internal or external flow or on a sealing surface. 3.4 structural welding the contractor shall perform any structural welding that is a result of a design requirement in accordance with LPR 1710.15, section 2.5, or the welding code or specification designated by the larc technical project engineer (TPE)/ research project engineer (RPE). All welding shall be qualified to the applicable code. Pre-qualified procedures are not accepted at larc. The NASA larc quality assurance certified welding inspector shall review the contractor s drawings and submittals. The contractor shall provide documentation to show that all welding efforts are done in accordance with the applicable sections of these specifications. The contractor shall submit one (1) copy of the welding procedure and qualification documents, to include the procedure qualification record (PQR), welding procedure specification (WPS), welder qualification record (WQR) as required by asme boiler & pressure vessel code, section IX, for review ten (10) working days prior to start of any welding.