Attach (4) Coordinate Measuring Machine Item Description Amendment 01.docx

DEPARTMENT OF THE AIR FORCE

OKLAHOMA CITY AIR LOGISTICS COMPLEX (OC-ALC)

TINKER AIR FORCE BASE OKLAHOMA

Item Description

MEMORANDUM FOR RECORD

SUBJECT: Item Description, C21-006 Coordinate Measuring Machine

1. The 76 CMXG is requesting utilization of funds for the purchase of a Coordinate Measuring Machine.

2. The requested software descriptions/specifications are outlined below.

· A bridge style CMM, able to measure variety of parts to an accuracy of 1.5 + L/333 microns or better. Length measuring uncertainties guaranteed from 18 - 22°C.

· Minimum table measurement range of x=500mm, y=700mm, z=500mm.

· Reference/Probe Qualification sphere.

· Automatic Stylus Changer.

· Stylus Kit with multiple probes from 3mm diameter to 8 mm diameter.

· Option to add optical sensors.

· 2.5 degree articulating head

· Scanning Probe

· Option to add optical sensors.

· Ability to program directly from CAD models

· Ability to create parametric programs

· Software must be compatible with Windows 10 Operating System

· Jog Box with single joystick or an operator panel with dual joysticks

· Air Dryer/Oil removal that supports a minimum of 10 CFM.

· Total footprint allocated for the installation of the CMM shall not exceed 72” by 72”.

· Room ceiling height is 102 inches. The ceiling is a drop ceiling, but the Government does not wish to raise the ceiling to accommodate a new CMM. However, if required, the Government will raise the ceiling tile directly over the final placement of the CMM. The ceiling tile directly over the CMM can be raised a height of 18” for a total ceiling height of 120”. The access doorway for the room is 71 inches wide by 83 inches tall.

· System shall operate on 120 VAC, 1 phase, 60 hertz with amperage not to exceed 20 amps.

· Low pressure air at 150 psig not to exceed 20 cfm.

· The contractor shall deliver and perform on-site installation of the CMM at 3538 C. Avenue, Tinker AFB, OK 73145 in Building 200, Room 118. The contractor will supply all transportation, rigging, forklift/crane, and labor necessary for offloading, transport and installation at permanent location.

· Operator Training for a minimum of 2 attendees (may be onsite, online or at contractor’s facility or combination thereof).

· Basic training - basic understanding of software and measurement capabilities of CMM and operating CMM for first time users.

· Advanced training - cover advance concepts beyond the basic training, such as importing CAD files for parts measurement, learning scanning concepts for analog scanning probes.

· Contractor must meet all requirements outlined in the Statement of Work (SOW).

3. Point of contact for this memorandum is Kirshten Crenshaw at (405) 582-4066 or e-mail at kirshten.crenshaw@us.af.mil.

image1.wmf