Attachment_H_-_CPI_wall_mounted_racks.pdf

IIS-71 1960. SHEET 2 OF 2 - INSTALLATION INSTRUCTIONS STANDARD SWING GATE WALL RACK- 1:10 . - ISS. - CPI/

A

LOOSEN

D

B

D J

C

SLOT U/L APPROVED BERS SHEET 2

f

11790-X12 11790-X18 11790-X25 11793-X12 11793-X18 11793-X25 11791-X12 11791-X18 11791-X25 11794-X12 11794-X18 11794-X25 11807-X12 11807-X18 11807-X25 11808-X12 11808-X18 11808-X25 11792-X12 11792-X18 11792-X25 11795-X12 11795-X18 11795-X25

INSTRUCTIONS

Step 1 Loosen hex bolt on pre-installed COMPONENTS corner ramp (D) and wall attachment cross-member (B).

Step 2 Slide legs (A) into position with slots fitting under previously loosened bolts.

Step 3 Tighten all bolts and install remaining hex bolts and hex nuts through remaining alignment holes with a 7/16" socket wrench.

Step 4 Use a level to assure wall rack is level while securing to wall.

Step 5 Align lower pivot pins of mounting frame (C) into lower corner ramps.

Retract upper pivot pins and secure in upper corner ramps.

Item

A

B

C

D

E

F

G

Quantity

Component Description ~--·1

Wall Attachment Brackets (Legs)

Wall Attachment Cross-Members

Mounting Frame

Corner Assembly Ramps (pre-installed in cross-members)

1/4" - 20 x 5/8 Hex Bolts

1/4" - 20 Hex Nuts

J..--16.00" for 19" width---1 I I 20.00" for 23" width - I I 0 O H 50 pack

1/4" x 2" Hex Lag Screws (not shown)

I I

Corner Mounting Locations (4 Places)

Also secure to wall through all additional holes.

24.15" for 24.5" height 38.15" for 38.5" height 48.65" for 49.0" height 73.15" for 73.5" height

_J

Note: Wall-mount rack must be secured using all possible hex lag screws (G) provided to 3/4" plywood back-board secured to wall framing to assure load bearing capability. Lag screws are intended for mounting to wooden surface; for masonry surface, the installer must provide appropriate hardware.

#12 - 24 Mounting Screws

CAUTION: Do not overload rack. UL approved racks can support up to 100 lb (45.4 kg) of equipment in the open and closed position when properly installed using all mounting holes. Load capacity can be increased by using a Heavy Duty Swing Gate Kit (sold separately). Contact your distributor for more information.

I

I C?I CHATSWORTH PRODUCTS. INC.

INSTALLATION INSTRUCTIONS

STANDARD SWING GATE

WALL RACK

THIS DRAWING CONf A!NS INFORMATION PROPll'ETARY TO CHI\TSWO RTH PRODUCTS. '1'lC. ANY REPRODUCTON Dl5CLOSURE OR USE Of THIS DRAWING JS C:XPRESSLY FORBOOEN EXCEPT

____ A_S A_ G_REE_D TO IN WRITING BY CHATSWORTH PRODUCTS, INC.

jrnehring Highlight jrnehring Highlight jrnehring Highlight jrnehring Highlight