066400 plastic paneling.pdf

F5W61608 USPFO Warehouse Ohio Army National Guard Rev. 0 Defense Supply Center Columbus, Ohio 30 January 2009 Bid Final

PLASTIC PANELING 066400 - 1

SECTION 066400 - PLASTIC PANELING

PART 1 - GENERAL

1.1 SUMMARY

A. Section includes glass-fiber reinforced plastic (FRP) wall paneling and trim accessories.

1.2 SUBMITTALS

A. Product Data: For each type of product indicated.

B. LEED Submittal:

1. Product Data for Credit EQ 4.1: For adhesives and sealants, including printed statement of VOC content and chemical components.

C. Samples: For plastic paneling and trim accessories.

1.3 QUALITY ASSURANCE

A. Surface-Burning Characteristics: As determined by testing identical products according to ASTM E 84 by a qualified testing agency. Identify products with appropriate markings of applicable testing agency.

1. Flame-Spread Index: 25or less.

2. Smoke-Developed Index: 450or less.

PART 2 - PRODUCTS

2.1 PLASTIC SHEET PANELING

A. General: Gelcoat-finished, glass-fiber reinforced plastic panels complying with

ASTM D 5319.

1. Manufacturers: Subject to compliance with requirements, provide products by one of the following:

a. Kemlite Company Inc.

b. Marlite.

c. Nudo Products, Inc.

Defense Supply Center Columbus, Ohio 30 January 2009 Bid Final

PLASTIC PANELING 066400 - 2

2. Nominal Thickness: Not less than 0.09 inch.

3. Surface Finish: Molded pebble texture.

4. Color: White.

2.2 ACCESSORIES

A. Trim Accessories: Manufacturer's standard one-piece vinyl extrusions designed to retain and cover edges of panels. Provide division bars, inside corners, and caps as needed to conceal edges.

1. Color: White.

B. Adhesive: As recommended by plastic paneling manufacturer.

1. VOC Content: 50g/L or less when calculated according to 40 CFR 59, Subpart D (EPA Method 24).

C. Sealant: Single-component, mildew-resistant, neutral-curing silicone sealant recommended by plastic paneling manufacturer and complying with requirements in Division 7 Section "Joint Sealants."

1. VOC Content: 250g/L or less when calculated according to 40 CFR 59, Subpart D (EPA Method 24).

PART 3 - EXECUTION

3.1 PREPARATION

A. Clean substrates of substances that could impair bond of adhesive, including oil, grease, dirt, and dust.

B. Condition panels by unpacking and placing in installation space before installation according to manufacturer's written recommendations.

C. Lay out paneling before installing. Locate panel joints where indicated.

3.2 INSTALLATION

A. Install plastic paneling according to manufacturer's written instructions.

B. Install panels in a full spread of adhesive.

C. Install trim accessories with adhesive.

Defense Supply Center Columbus, Ohio 30 January 2009 Bid Final

PLASTIC PANELING 066400 - 3

D. Fill grooves in trim accessories with sealant before installing panels and bed inside corner trim in a bead of sealant.

E. Maintain uniform space between panels and wall fixtures. Fill space with sealant.

F. Remove excess sealant and smears as paneling is installed. Clean with solvent recommended by sealant manufacturer and then wipe with clean dry cloths until no residue remains.

END OF SECTION 066400