The file's text, extracted by GovTribe without its formatting.
GMTK Took Chest – Technical Information Questionnaire (TIQ)
Company:________________________________ Cage Code:_______________________ POC: ____________________________________ POC Telephone:___________________ POC Email:_______________________________
The following TIQ is intended to support the Government’s determination whether the proposed GMTK Tool Chest is technically acceptable and is capable of meeting the performance requirements outlined in the Solicitation and attached drawings. The proposer’s failure to answer each of the questions in this TIQ and submit substantiating data may result in the rejection of the proposal. Every question must be supported with substantiating data as detailed in RFP Section L.3.2 and below. The product offered must meet ALL of the capabilities and requirements as described in the Item Description and specification (attachment 0001) for the GMTK Took Chest. Please answer every question below indicating via an “X” in the “Yes” or “No” column. Substantiating data shall also be attached to this completed TIQ. The substantiating data for questions shall be in the form listed in the column titled “Verification”.
Vendor Response
| Item # |
| Evaluation Question |
| Reference: Description |
| Verification |
| Yes |
| No |
| Proposal Location of Substantiating Data |
| 1 |
| Are the tool chest drawers fully extendable so that all portions of the drawer are accessible with each tool able to be lifted straight up out of any drawer without interference with the tool chest or other drawers no matter where it is located in the drawer? |
| Drawing 0627B0000, note 3.4.6 |
| Provide written response and drawings/figures of one drawer highlighting accessible space claim for proposed tool placement, taking into consideration tool chest overlap. |
| 2 |
| Does the tool chest have an adequate number or size of side handles for a 4-person lift? |
| Drawing 0627B0000, note 3.5.1 |
| Provide drawings/figures to depict proposed handle locations and manufacturer’s specification sheet for proposed handles. |
| 3 |
| Are the tool chests stackable and crush resistant when loaded with no less than 3 other identical tool chests, each loaded to 120 pounds, stacked on top of it? |
| Drawing 0627B0000, notes 3.8.2 and 3.8.3 |
| Provide test report for proposed or similar tool chest. |
| 4 |
| Is the tool chest rated for use in temperatures from -25°F to +170°F? |
| Drawing 0627B0000, notes 3.8.6 and 3.8.10 |
| Provide test reports, commercial item literature, user manuals, or material specification sheets for the proposed or similar tool chest. |
| 5 |
| Is the tool chest resistant to water entry when immersed in water to a depth of no less than 1 meter (3.28 feet) for no less than 30 minutes? |
| Drawing 0627B0000, note 3.8.7 |
| Provide test report for proposed tool chest. |
| 6 |
| Is the tool chest equipped with a pressure relief valve that regulates air with changing altitude and temperature to equalize pressures while prohibiting the intrusion of water and dust? |
| Drawing 0627B0000, note 3.8.12 |
| Provide manufacturer’s specification sheet for proposed relief valve. |
| 7 |
| Does the tool chest resist dust entry when the dust is blowing at a velocity of 8.9 meters/second (1750 feet/minute)? |
| Drawing 0627B0000, note 3.8.9 |
| Provide test report for proposed or similar tool chest. |
| 8 |
| Is the tool organizing liner closed-cell, cross-linked foam with a density of 4 to 6 lbs per cubic foot and a water absorption of no more than 0.02 lbs/ft2 over cut surfaces when tested in accordance with ASTM D3575? |
| drawing 0627C0000 |
| Provide manufacturer’s material specification sheet. |
