Recovery design build services new custom house

This is a Recovery Project:

This procurement has been determined by the Small Business Administration (SBA) as an 8(a) competive set-aside

The Small Business Administration requirement number assigned is:
0811.10.000309.

 Joint Venture Agreements - Joint Venture are allowable on competitive 8(a) set-asides, however, the joint venture agreement must be received by SBA prior to proposal due date and approved before award of any resulting contract.  If you are contemplating a joint venture on this project, you must advise, in writing, your assigned SBA Business Development Specialist (BDS) as soon as possible.  It is also recommended that the agreement be submitted as soon as practicable to ensure compliance with established regulations.  Any corrections and/or changes needed can be made only when your BDS has adequate time for a thorough review before the proposal due date. NO CORRECTIONS AND/OR CHANGES ARE ALLOWED AFTER TIME OF SUBMISSION OR PROPOSAL OR BIDS.

This offer is no geographical restriction listed for this project

Request for Qualifications (RFQ)
GS-08P-10-JB-C-0007
Design Build Services
for the Modernization of the
New Custom House
Denver, Colorado

Phase I Technical Submittal

Prepared by:
U.S. General Services Administration
Public Building Services, Colorado Service Center
Denver, Colorado

 PART I:    Project Requirements

 1.0        Project Overview

1.1        Organization of RFQ

1.2        Services to be Provided

1.3        Project Summary

1.4        Summary of Acquisition Strategy

1.5        Source Selection Evaluation Criteria

PART II:  Qualifications Submittal Requirements

2.0        Estimated Award Date

2.1        Estimated Completion Date

2.2        RFQ/RFP Evaluation Criteria and Basis of Award

2.3        Questions, Clarifications and Interpretations

2.4        Required Technical Data for Qualifications Submittal

2.5        Qualifications Submittal Preparation

2.6        Qualifications Submittal Delivery Date and Location

2.7        Qualifications Submittal Sealing

2.8        Phase One Submission

PART III:  Past Performance Questionnaire

PART IV:  Projects

 PART V:  FAR Clauses

 APPENDIX:

Standard Form 330
Architect/Engineer Qualifications

This procurement has been designated as an 8(a) set-aside.  Please see attached RFQ Phase I Technical Submittal and SF330


Request for Information (RFI) deadline is no later than close of business day (MST) November 20, 2009.  No RFIs will be accepted after November 20, 2009