Add_1_SECTION_16_50_00_LIGHTING.pdf

MAHG10-1032

SECTION 16 50 00 - LIGHTING

PART 1 GENERAL

1.1 RELATED DOCUMENTS

A. Furnish and install lighting fixtures, complete with lamps, in accordance with this section.

For purposes of identification, certain manufacturers and catalog numbers have been specified. Fixtures of other manufactures of equal quality, general dimensions, photometric characteristics, and appearance will be acceptable upon approval by Contracting Officer. Comply with Paragraph 16000-1.06 before bidding. Section 16000 - Electrical General Requirements, apply to the work specified in this Section, with additions and modifications specified herein.

1.2 SECTION INCLUDES

A. Luminaries B. Shielding Media C. Lamps D. Ballasts E. Installation of Fixtures

PART 2 PRODUCTS

2.1 PRODUCTS

A. Luminaire shall be manufactured by Hubbell Outdoor Lighting model no. PGM3-070P-18- BZ-L or approved equal.

1. Product requirements for each luminaire are as follows:

a. HOUSING: Cast aluminum door frame with prismatic glass refractor. Door seals to housing gasket with twin Hubbell Gard® captive fasteners Die cast aluminum housing allows firm mounting over recessed junction boxes or on flat surfaces for 1/2” surface conduit. Casting dissipates ballast heat for long life. Top hub supplied for field installation of button photo control, ordered separately

b. LIGHT CONTROL:

Specular aluminum reflector with kicker panels. Vertical socket position to provide six to one spacing to mounting height ratio for maximum spacing.

c. ELECTRICAL: PGM features 70-250w HPS and pulse start metal halide.

QuadTap®, 347V and 50Hz 220/240V

d. FINISH: Each standard luminaire to receive a fade and abrasion resistant, electrostatically applied, thermally cured, textured TGlC polyester powder-coat finish. Dark bronze 800 Series powder paint finish standard on frame and housing.

e. LABELS: All luminaires bear UL or CUL (where applicable) Wet Location labels.

f. WARRANTY: 5 year limited warranty. Polycarbonate lenses to carry a 1 year warranty only.

B. Accessories: Provide required accessories for mounting and operations of each luminaire as indicated.

1. Thermal Protection: Provide thermal protection devices to meet NFPA 70 requirements.

2. Surface Luminaries: Provide spacers and brackets required for mounting.

2.2 LAMPS

A. Provide lamps for all fixtures.

Section 16 50 00_1-2

MAHG10-1032

B. Description:

1. Pulse start metal halide.

2.3 BALLASTS-not applicable

2.8 INSTALLATION OF FIXTURES

A. Provide adequate support for all fixtures.

B. Contractor to verify facility and site voltage prior to ordering fixtures.

PART 3 EXECUTION

3.1 EXAMINATION AND PREPARATION

A. Examine adjacent surfaces to determine that surfaces are ready to receive work.

3.2 INSTALLATION

A. Install luminaries and accessories in accordance with manufacturer's instructions.

1. Install luminaries so that there is no light leakage around fixture trim. Support fixtures in accordance with Article 410-16 C of the National Electrical Code.

2. Install lamps in luminaries and lamp-holders.

3.3 ADJUSTING AND CLEANING

A. Align luminaries and clean lenses and diffusers at completion of work.

B. Aim adjustable luminaries and lamp-holders as indicated or as directed.

C. Clean paint splatters, dirt and debris from installed luminaries.

D. Re-lamp luminaries, which have failed lamps at completion of work.

E. Touch up luminaire at completion of work.

F. Adjust relays, timers, photo controls, etc. to achieve specified or directed operation.

END OF SECTION

Section 16 50 00_2-2