Questions_and_Answers_vol._2_-_R-0021_Win_Mag.pdf

Questions Answers

Reference 1.1 – Is this ammunition being utilized for “Competition” or “Duty” applications? If it is for “Duty” applications, what are the criteria for terminal performance – such as required penetration depths in gelatin, maximum cavity, expansion rates, initial penetration, barriers, etc.?” At what distance from the muzzle will this testing occur?

This ammunition will be utilized for operational duties. The Secret Service currently has no terminal performance specifications connected to this contract.

2 Reference 3.4.2 – In regards to “tipping” does this mean that a polymer tip is acceptable or does it have to be an open tip (hollow point) design as described?

"Tipping" in this case means Changing the angle of the forward end the ogive to reduce the meplat and increase the BC.

Reference 3.8 – Are there any specifications in regards to pressure for ammunition being shot in higher or lower temperature ranges ie, “real world conditions”?

Testing will be performed following the ANSI/SAAMI Z299.4 and shall be temperature conditioned between 60 1/2 F and 80 1/2 F for a minimum of two hours. No other testing will be performed.

Reference 3.9.1, 3.9.3, 3.9.5 – How will environmental conditions be addressed in regards to firing the test samples for accuracy?

100 yard testing will be conducted in an enclosed range. When firing test

600 and 1000 yards care will be taken to fire in calm conditions and we will focus on vertical dispersion.

Reference 3.9.4 and 3.9.6 – If none of the ammunition submitted can meet the

MOA accuracy criteria on a repeatable basis at 600 and 1000 yards, will the contract be awarded to the manufacturer with the best group size or how will this be decided?

The ammunition must meet this minimum requirement. If no samples meet the requirement, the Government reserves the right to cancel the solicitation.

6 Reference 4.0 – What equipment will be utilized to measure bullet push/pull? Rimic Tools Spring tester

Reference 4.0 – If the push/pull it outside of 40 pounds +/- 10 pounds will the lot be rejected?

If any ammunition does not meet the specification it will be eliminated.

Reference 4.2.1 – Since an AX-AICS, a McMillan A-3, and McMillan A-5 stocks are mentioned in the SOW. What are the specifications for each of the USSS

Remington 700 rifles, bolt, magazine OAL, stock, barrel, twist rate, chamber reamer, etc. utilized in function testing and accuracy for this request?

The overall length of the loaded cartridge shall be 3.280 inches minimum, and 3.50 inches maximum. Optics – Leupold Mark-4 M-1 10X or Mark-4

6.5X20X50 long range tactical. Barrel – Schneider Rifle Barrel, 1-10 twist stock #SRBJAR30810, 26 inches in length , Stock- Accuracy International

(Funtion test).

Barrel – Schneider Rifle Barrel, 1-10 twist stock #SRBJAR30810, 26 inches in length

Chamber Specification - .300 Winchester magnum standard minimum specification with the exception of .150 inch free bore, .339 neck diameter.

Reference 4.4 – We currently package our ammunition in 200 round cases (10 boxes of 20) – will this be acceptable for this contract?

We require 400 rounds per lot to maintain operational status