Main Gate Entry Control Point Upgrade

Amendment 0001: Upload Drawings and Request for Information (RFI) Sheet to FBO.Gov. RFI's should be emailed to Christine.m.walker30.mil@mail.mil. All RFI's to be submitted No Later Than 3 July 2019 1200 PM CST with responses posted to FBO.Gov No Later Than 9 July 2019 3:00 PM CST. -- System not allowing for Drawings Upload.  Email Christine.m.walker30.mil@mail.mil for emailed Drawings or a disc can be picked up from Will Rogers Air National Guard Base 5901 Air Guard Drive OKC, OK 73179. 

Synopsis:

Entry Control Point (ECP) Upgrades, Main Gate Project Number: YZEU152007.

The work to be accomplished under this contract consists of furnishing all labor, tools, equipment, materials, accessories, and incidentals necessary to perform the task list below (but not limited to) description and also shown on the contract drawings and specifications.:

The objective of this project is to complete construction on entry-control upgrades to achieve compliance with current security criteria.

This project is being solicited as a Small Business Set Aside. The North American Industry Classification System (NAICS) code is 236220, and the Small Business Size Standard is $36.5M in average annual receipts for the past three years. Construction project magnitude is between $250,000.00 to $500,000.00. Persons who intend to bid are strongly encouraged to attend the Pre-Bid Conference. See Section 00100 for location and date. All documents including the plans and specifications will be available only from the Fed Biz Ops website: www.fbo.gov

Solicitation cover page:

SUMMARY OF WORK

PART 1 GENERAL

1.1 WORK COVERED BY CONTRACT DOCUMENTS

•1.1.1    Project Description

Complete construction on entry control upgrades.

Civil (where indicated on plans):

•           Demolition of existing asphalt pavement, concrete pavement and concrete curbs to prepare for installation of new pavement, islands and curbs.

•           Removal and reinstallation of existing bollards where indicated on the drawings.

•           Removal of existing cable barrier and footings.

•           Install new concrete raised center islands to separate inbound and outbound lanes in the response zones and to channelize the threat vehicle. Center islands to be colored and textured concrete and curbs.

•           Install new concrete pavements at roadway where indicated.

•           Re-core pavement and reinstall existing bollards.

•           Install concrete bollard storage area.

•           Install three swing gates to improve truck operations.

•           Install cable barrier for new inbound truck operations improvements.

•           Install new traffic signal pole, lighting and wiring. Coordinate with Electrical.

•           Install speed limit signage and concrete base.

•           Install new 12'x12' concrete pad.

•           Assorted roadway paint striping.

Electrical (where indicated on plans):

•           Removal and reinstallation of existing light poles.

•           Removal of existing traffic lights.

•           Installation of new lighting at Guard House.

•           Install new traffic signal pole, lighting and wiring. Coordinate with Civil.

•           Install new light fixtures on existing light poles.

•           Install new motion sensors on existing light poles.

•           Install new light poles, conduit and wiring at raised Concrete Island. Connect to existing Guard Shack Panel.

•           Install new receptacle outlet at covered inspection area.

A site visit will be held: 25 June 2019, 1300 PM CST

Will Rogers Air National Guard Base OKC, OK 73179

BLDG 1007 Conference Room