Drydock for CGC skipjack and CGC manta

11/19/12
AMENDMENT (A00003) is issued to Solicitation No. HSCG80-13-R-P45033 is hereby amended as follows:

1. TO INCORPORATE A NEW SCHEDULE OF SUPPLIES AND SERVICES FOR CGC SKIPJACK DATED 11/19/2012. Specific change is to CLIN 24.

2. DUE DATE FOR PROPOSALS FOR CGC SKIPJACK WILL BE EXTENDED UNTIL 11/20/12 @ 12:00 E.S.T.
IF YOU'VE SUBMITTED A PROPOSAL FOR CGC SKIPJACK AND PRICING REMAINS, PLEASE SIGN THIS FORM AND SUBMIT THIS TO THE CONTRACTING OFFICER LISTED BELOW.

PRE-SOLICITATION:

The United States Coast Guard, Surface Forces Logistics Center, Detachment Norfolk VA, intends to issue a Commercial Request for Proposal (RFP) for Dry-dock and repairs to the CGC SKIPJACK (WPB-87353) and CGC MANTA (WPB-87320) both 87-Foot Patrol Boats. The NAICS Code is 336611.

The Coast Guard intends to conduct the procurement in accordance with Federal Acquisition Regulation (FAR) Part 12, Acquisition of Commercial Items, and FAR Part 15, Contracting by Negotiation for Certain Commercial Items. The simplified acquisition will be issued as a Small Business Set-Aside. Request for Proposals (RFP) will be issued on or about September 19, 2012.

The acquisition is to perform drydock and repairs to the CGC SKIPJACK and CGC MANTA. The vessels are geographically restricted to a facility located within an area no greater than 500 nautical miles one-way and 1000 nautical miles roundtrip from Galveston, TX. The Period of performance for CGC SKIPJACK is FORTY-FIVE (45) calendar days from 30 JAN through 15 March 2013. The Period of performance for CGC MANTA is FORTY-FIVE (45) calendar days from 1 MAY through 14 JUN 2013. All work will be performed at the contractor's facility within the geographical restriction as stated above.

The solicitation will be issued electronically via the Federal Business Opportunity web page at http://www.fedbizopps.gov. It is incumbent upon contractors to monitor the FEDBIZOPS web page for the RFP release and all subsequent amendments. Hard copies of the specification and solicitation will not be issued.

The scope of the acquisition is for the overhauling, renewing and repairing of various items aboard the CGC SKIPJACK and CGC MANTA. This work may include, but is not limited to:

1. Perform Ultrasonic Thickness Measurements
2. Perform Ultrasonic Thickness Measurements
3. Bilge Surfaces (Engine Room), Preserve (Partial)
4. Bilge Surfaces (Mess Deck), Preserve (Partial)
5. Dirty Oil Tank, Clean and Inspect
6. Oily Water Tank, Clean and Inspect
7. Tanks (MP Fuel Service), Clean and Inspect
8. Pilothouse Deck (Aluminum), Inspect, Preserve, and Renew Electrical Matting
9. Depth Sounder, Capastic Fairing, Renew
10. Main Engine/Reduction Gear, Realign
11. Propulsion Shafts, Remove, Inspect, and Reinstall
12. Propulsion Shaft, Repair
13. Propulsion Shaft, Straighten
14. Intermediate Water-Lubricated Propulsion Shaft Bearing, Renew
15. Aft Water-Lubricated Propulsion Shaft Bearing, Renew
16. Intermediate Bearing Carrier, Renew
17. Aft Bearing Carrier, Renew
18. Stern Tube, Interior Surfaces, Preserve 100%
19. Stern Tube, Interior Surfaces, Repair
20. Propellers, Remove, Inspect, and Reinstall
21. Propeller, Minor Reconditioning and Repairs, Perform
22. Fathometer Transducer, Renew
23. Speed Log, Skin Valve Assembly, Clean and Inspect
24. Sea Water System (Sea Valves, Strainers, Piping), Clean, Inspect, and Repair
25. Rudder Assemblies, Remove, Inspect and Reinstall
26. RHIB Notch Skid Pads, Inspect
27. RHIB Notch Skid Pad Studs, Renew
28. Stern Launch Door, Remove, Inspect and Reinstall
29. Grew Water Holding Tank, Clean and Inspect
30. Sewage Holding Tank, Clean and Inspect
31. Grey Water Piping, Clean and Flush
32. Sewage Piping, Clean and Flush
33. U/W Body, Preserve 100%
34. Cathodic Protection/Zincs, Renew
35. Drydocking 36.
36. Temporary Services, Provide
37. Telephone Service, Provide
38. Ventilation System, Engine Room Supply and Exhaust Fan Assemblies, Clean and Inspect, Preserve
39. Main Diesel Engine, Renew
40. Ship Service Diesel Generator, Renew
41. Mast, Preserve 100%

A CD-ROM containing all applicable drawings will be sent via U.S. mail, if requested. Send all requests to Nancy.M.Brinkman@uscg.mil The CD-ROM sets are available of all cutters and will be free of charge to contractors upon request. The CD-ROM(s) contain WINDOWS compliant raster/vector formats (e.g.*.DWF, etc).

Proposals are due on or about October 19, 2012 at 10:00 a.m. Eastern Standard Time and may be sent via:

Email: nancy.m.brinkman@uscg.mil or mailed to

US Coast Guard
SFLC/C&P1/PBPL
Attn: Nancy Brinkman
300 East Main Street, Suite 600
Norfolk, VA 23510-9102