A21._Coffee_Table_Salient_Characteristics.pdf

Technical Proposal

Coffee Table: Same or Equal dimensions/capacity and function is acceptable for Salient Characteristics.

ITEM – COFFEE TABLE - 46”W X 27”D X 18”H, MAHOGANY COLOR

COFFEE TABLE SPEC

Item. Coffee Table (Quantity 100)

SIZE: 46”W X 27”D X 18”H

A. EXTENDED DESCRIPTION:

(1) All items shall meet or exceed section of ANSI/BIFMA X5.5-1989.

(2) All case goods shall be constructed in accordance with AWI 400.

(3) All wood shall be kiln-dried to a moisture content of 5-8%.

(4) Adhesive shall conform to ASTM D-905 block shear strength of not less than 19 300 Kpa (2800 lbs per sq in).

B. SPECIFICATIONS:

(1) 19mm top panel and 25mm supplementary panel shall be made using Solid Oak Wood Bonded material. The Solid Oak Wood Bonded Material shall have no knots in the wood.

(2) Color: Mahogany (Repeat 10 times and finish with a polyurethane paint).

(3) Legs shall be curved of Solid Oak wood

(4) Legs shall be joined in wooden pieces.

(5) Finish shall comply with AWI Section 1500 system 1 or 7 unless otherwise indicated.

a. Preparations for Finishing: Comply with referenced quality standard for sanding, filling countersunk fasteners, sealing concealed surfaces of Architectural woodwork, as applicable to each unit of work.

b. Wash-coat for Stained Finish: Apply a vinyl wash-coat to woodwork made from closed-grain wood before staining and finishing.

c. Filled Finish for open-Grain woods: After staining (if any) apply paste wood filler to open-grain woods and wipe off excess.

d. Transparent Finish: Comply with requirements indicated below for grade, finish system, staining, effect, and sheen, with sheen measured on 25 degrees gloss meter per ASTM D 523.

(a) Grade: Premium.

(b) Staining: Matched approved sample for color.

(4) Corner brackets shall be nickel plated steel sheet.

(5) Adhesives: The adhesives shall be urea-resin or phenol-resin. The adhesives shall be used in strict accordance with the manufacturer's instruction. Adhesive shall be used on all joints in reassembling. Joints shall be true perfect, well glued throughout and held under pressure until adhesive has set.

(6) Floor Protector: Material such as kind of material (wood only not plastic), construction, size, density etc. shall be similar to those in the original item.

(7) WARRANTY: Warranty for vendor shall be at minimum two years in a written statement.

(21) Upon receipt of award, the contractor shall provide one (1) sample product with a full size for approval within 14 calendar days. Once the sample product is approved, the contractor shall deliver entire quantities within 45 days of acceptance of sample product.