A21._CHAIR,_DINNING_without_Arms_(AFH).doc

Chair, Dinning w/o Arm: Same or Equal dimensions/capacity and function is acceptable for Salient Characteristics.

ITEM – CHAIR, DINNING W/O ARMS- 24”W X 24”D X 40”H, MAHOGANY COLOR

CHAIR, DINNING W/O ARMS SPEC

Item. Chair, Dinning w/o Arms (Quantity 300)

SIZE: 24”W X 24”D X 40”H

A. EXTENDED DESCRIPTION:

(1) All items shall meet or exceed section of ANSI/BIFMA X5.5-1989.

(2) All case goods shall be constructed in accordance with AWI 400.

(3) All wood shall be kiln-dried to a moisture content of 5-8%.

(4) Adhesive shall conform to ASTM D-905 block shear strength of not less than 19 300 Kpa (2800 lbs per sq in).

B. SPECIFICATIONS:

(1) Frame: Natural Oak Wood (Crossing Joint System), Urethane Coating (More than 6 times), not using MDF or Particle board.

(2) Color: Mahogany for Wood (Repeat 10 times and finish with a polyurethane paint).

(3) Color: Burgundy for Fabric.

(4) Seat: PU Sponge + Cloth (Burgundy)

(5) Seat: Disassemble condition required for re-upholstering.

(6) Chair Gliders: on the beneath of all the legs, to prevent any scratches on the floor.

(7) Fabric must be anti-fouling (waterproof) and non-flammable.

(8) Vendor must provide to FMB Flame Resistant Certification by Korea Fire Department.

(9) Finish shall comply with AWI Section 1500 system 1 or 7 unless otherwise indicated.

a. Preparations for Finishing: Comply with referenced quality standard for sanding, filling countersunk fasteners, sealing concealed surfaces of Architectural woodwork, as applicable to each unit of work.

b. Wash-coat for Stained Finish: Apply a vinyl wash-coat to woodwork made from closed-grain wood before staining and finishing.

c. Filled Finish for open-Grain woods: After staining (if any) apply paste wood filler to open-grain woods and wipe off excess.

d. Transparent Finish: Comply with requirements indicated below for grade, finish system, staining, effect, and sheen, with sheen measured on 25 degrees gloss meter per ASTM D 523.

(a) Grade: Premium.

(b) Staining: Matched approved sample for color.

(10) Adhesives: The adhesives shall be urea-resin or phenol-resin. The adhesives shall be used in strict accordance with the manufacturer's instruction. Adhesive shall be used on all joints in reassembling. Joints shall be true perfect, well glued throughout and held under pressure until adhesive has set.

(11) Floor Protector: Material such as kind of material (wood only not plastic), construction, size, density etc. shall be similar to those in the original item.

(12) WARRANTY: Warranty for vendor shall be at minimum three years in a written statement.

(13) Upon receipt of award, the contractor shall provide one (1) sample product with a full size for approval within 14 calendar days. Once the sample product is approved, the contractor shall deliver entire quantities within 45 days of acceptance of sample product.

(14) Vendor must Attached Outside of box Information sheet.

High-39”(inch)

Width-22”(inch)

Depth-21”(inch)

92.25mm

70mm

60mm

43.53mm

24.83mm

11.93mm

The seats: disassemble conditions required for re-upholstering

Chair Glides: on the beneath of all the legs, to prevent any scratches on floor

Technical Proposal