Amend 02 Rock House Fence Diagram Attachment.docx

Attachment: Rock House Fence Re-Configuration.

Clarification for Fence Re-Configuration.

For Items 1-4, use existing materials. For Items 5 and 6, furnish and install new barbed wire fence. The diagram below illustrates the solid line is the new configuration and the “xxxx” are the existing configuration.

1. Remove approximately 300’ of old wood barbed wire fence where it parallels the new fence on the east side of the cell. Materials from old fence are to remain on site.

2. At the 4-way gate junction on east side, re-install one of the metal ranch gates perpendicular to the new fence. Take the second metal ranch gate and install it at the north location. Take the wire gates and reinstall then on the south and west openings. The west gate may take some reconfiguration to allow for the gate.

3. Install a wire man-gate (6’ in width) into the cell at an easily accessible location.

4. Rancher is to remove any trees authorized by COR

5. Add 330’ of a new 5th barbed wire around the cell

6. Remove 330’ of the smooth wire on the new fence and ADD 330’ of new wire.

Currently there are 2 metal ranch gates at this location. Adjust one metal gate to fit new opening and move the second one to the north fence opening. The wire gates are to be moved to the south and west gate locations and installed.

W S E N Install metal gate moved from east side tie into new fence.

Remove the old fence along the east and SE sides of the cell. Connect gates to the new fence. Leave removed fence material nearby for rancher.

Install barbed wire gate moved from east location.

Adjust existing wire gate to fit with new fence Adjust existing metal gate to fit with new fence Add 5th barbed wire and replace smooth wire with barbed wire around the entire cell.

Install man-gate (6’) out of barbed wire in new fence. Here or elsewhere along the new fence N Current Task Order includes tightening the new barbed wires.

image1.png