02b. PCID 1067 Eff 070524.pdf

Vehicle Delivery Requirements PCID NO. 1067

General Requirements for Delivery of Vehicles (This item description supersedes PCID 1067, effective October 10, 2019)

PCID NO. 1067

Eff. 7/5/24

The following delivery requirements shall apply to the vehicle as specified by the ordering agency. These requirements are in addition to, but not limited to, the vehicle specification provided as part of the solicitation document, and are exclusively for Executive and Independent Agencies of the Commonwealth of Pennsylvania as well as direct purchases through the Department of General Services. Unless otherwise noted on the request for proposals or invitation for bids, deliveries shall be made to the Department of General Services (DGS), Commonwealth Garage, 22nd and Forster Streets, Harrisburg, Pennsylvania, phone (717) 787-4252.

NOTE: Deliveries for the Department of Transportation (PennDOT) shall be made to the PennDOT Equipment

Division, headquartered in Harrisburg, Pennsylvania, phone (717) 787-2123. Deliveries for the Pennsylvania State

Police (PSP) shall be made to the PSP Transportation Division headquartered in Harrisburg, Pennsylvania, phone

(717) 787-1318.

1.0 GENERAL REQUIREMENTS SECTION

1.1 The vehicle Manufacturer's model name and/or model number shall be indicated on a decal affixed inside the door.

1.2 Standard solid exterior colors with standard interior trim shall be selected after the award is made unless otherwise indicated in the proposal.

1.3 Tire size and type shall be original equipment brand or as indicated in the proposal or specification sheet. Tire inflation monitors shall be supplied as required by Federal Motor Vehicle Safety Standard (FMVSS) 138.

1.4 All vehicles shall be new and of the model year indicated in the proposal.

1.5 All vehicles shall include all genuine parts, accessories and equipment considered standard by the manufacturer for the vehicle offered by the supplier.

1.6 All vehicles shall have a valid PA state inspection sticker and a valid PA emissions inspections sticker (for all vehicles subject to the PA I/M Program). NOTE: New or current model year vehicles with less than 5,000 miles, subject to the PA I/M program, must display a valid PA emissions inspection sticker with an exemption indicator. All

Pennsylvania state inspection requirements are the sole responsibility of the supplier.

1.7 All vehicles shall have completed the manufacturers’ recommended pre-delivery service.

1.8 All vehicles shall be clean, lubricated, serviced, fuel tank filled to full recommended capacity, all adjustments completed, all mechanical and electrical components fully functional and operational, and the vehicle will be “road ready” for immediate use.

NOTE: Supplier shall not remove the manufacturer’s MSRP (Monroney) sticker and/or dealer sticker price prior to delivery. Stickers should be affixed to an interior surface of the vehicle window and legible from outside of the vehicle. Stickers shall be easily removable without any permanent marking left on the glass. Incomplete chassis shall have the sticker included loose with the delivery documents.

1.9 All vehicles shall have appropriately placed decals or manuals indicating the types of required fuels or lubricants and the capacity of each fluid’s reservoir in accordance with the manufacturer’s recommendation.

COMMONWEALTH OF PENNSYLVANIA

PENNSYLVANIA COMMERCIAL ITEM DESCRIPTION (PCID)

1.10 All vehicles shall have permanent antifreeze in each vehicle to protect it at a level of -35F.

1.11 All vehicles shall be free from all dealer signs/emblems.

1.12 All vehicles shall have all required rust proofing applied to the exterior and underside of the vehicle. No rustproofing compound can be on the personnel compartment’s items or the exterior of the body in unsightly or unintended areas.

1.13 All vehicles shall include a copy of the manufacturer’s warranty and service policy with all warranty vouchers, certificates and coupons.

1.14 Each vehicle shall include the proper forms to apply for Pennsylvania title and license including the original manufacturer's Statement of Origin signed by the dealer/supplier and notarized and shall indicate the owner name and address as follows: Pennsylvania Department of General Services, 2221 Forster Street, Harrisburg, Pa 17125.*

*VEHICLES DELIVERED TO PA DEPT OF TRANSPOTATION SHALL BE TITLED ACCORDINGLY.

1.15 At the time of vehicle delivery, the successful supplier shall furnish an original and one (1) copy of the invoice which shall include the key number, vehicle color and Commonwealth purchase order number, contract number (if applicable) and indicate ordering agency. To ensure prompt payment the dollar amount of the supplier’s invoice must match the purchase order amount.

1.16 The successful supplier shall comply with the manufacturer's warranty, or authorize a qualified dealer in the locality in which the unit is assigned to do whatever is required to comply with the manufacturer's warranty.

1.17 The successful supplier shall submit at least two (2) copies of all service/technical bulletins, recall notices, etc. to the Director, Bureau of Vehicle Management, Department of General Services, 2221 Forster Street, Harrisburg, Pennsylvania 17125. These documents shall be submitted on a continual basis to keep the Bureau of Vehicle

Management informed regarding improvements, changes and/or problems concerning Commonwealth owned vehicles and their component parts.

1.18 The Department of General Services, Bureau of Vehicle Management, will inspect all vehicles prior to acceptance. It will be the responsibility of the supplier to remove any vehicle rejected by the Bureau of Vehicle

Management within two (2) working days after notification, and return the vehicle to the Commonwealth Garage upon correction of deficiencies. Date in service will be the date the vehicle is accepted by the Commonwealth, not the date of delivery.

1.19 The Commonwealth disclaims any liability for damage to vehicles not unconditionally accepted by the

Commonwealth.

1.20 Unless otherwise indicated, all items requested in this specification which are listed in the manufacturer's specification book as standard or optional equipment shall be factory installed and operative. Vehicles delivered to the

Commonwealth in a condition considered to be below retail customer acceptance levels will not be accepted. Items which determine this acceptance level shall include, but not be limited to, the general appearance of the interior and exterior of the vehicle for completeness and quality of workmanship, lubrication and fluid levels, with any leaks corrected, mechanical operation of the vehicle and all electrical components operational. Allied equipment specified to be furnished and installed which is not available through the vehicle manufacturer shall conform to the best quality standards known to that particular industry, both product and installation.

1.21 Trucks with snow plows being delivered to the Commonwealth Garage for inspection, are required to have the snow plow stored in the truck bed. Failure to do so will show cause for rejection of inspection.

1.22 All vehicle deliveries shall be coordinated through the DGS Bureau of Vehicle Management. Suppliers shall call

(717) 787-4252 for delivery schedule at least 48 hours in advance. When vehicles are purchased by Pennsylvania

State Police, the successful supplier shall call (717) 787-1318 (PSP). When vehicles are purchased by Pennsylvania

Department of Transportation, the successful supplier shall call (717) 787-2123 (PennDOT) for information regarding invoicing and delivery.

1.23 Vehicle Delivery: Mileage limitations are placed upon vehicles delivered in accordance to these requirements as indicated below. If the mileage upon delivery exceeds these limits, a credit of $5.00 per mile will be applied against the awarded supplier’s purchase order as damages and deducted at time of payment. If the awarded supplier uses a towing device to tow another vehicle to the Commonwealth Garage for delivery, the towing device may not be attached in a way that holes are drilled in the bumpers of the vehicles being towed. Drilling of holes in the vehicle bumpers is not permitted. Any bumper damage caused by a towing device will be replaced by the awarded supplier at no charge to the Commonwealth. If a vehicle is being towed by another vehicle, the vehicle being towed must have the drive shaft disconnected to eliminate unnecessary mileage.

1.23.1 Class 1 to 3 factory completed vehicles: mileage displayed on the vehicle odometer shall not exceed 400 miles.

1.23.2 Class 2 to 6, factory incomplete vehicle: mileage displayed on the vehicle odometer upon delivery with final stage manufacturer certification shall not exceed 1,000 miles.

1.24 Pennsylvania Clean Vehicles Program Requirement: Supplier is responsible to ensure that all supplied vehicles are compliant with all applicable Title 25 requirements (25 Pa. Code, Chapter 126, Subchapters D or E). This compliance shall be evidenced on the manufacturer’s certificate of origin (MCO), or, alternatively, by submission of a completed MV-9. If supplied vehicles are not compliant, they cannot be titled in Pennsylvania and the delivering supplier shall be responsible to pick up and return the vehicle by replacing it with a California or “50-state” emissions certified vehicle that is compliant with all Title 25 requirements

2.0 REQUIRED EQUIPMENT SECTION

The following items shall be supplied on all vehicles as Minimum required equipment, unless otherwise superceded in the request for proposals or invitation for bids.

2.1 Lug wrench on all trucks and jacks on trucks up to and including 10,000 lbs. GVWR.

2.2 Air conditioning integral with the heater and defrosters.

2.3 Dual electric intermittent windshield wipers.

2.4 The rustproofing shall be factory or locally applied in compliance with Federal Standard 297A. Warranty coupon for five (5) years, at no cost to the Commonwealth, shall be furnished with each vehicle*.

* NOT APPLICABLE IF THE VEHICLE FURNISHED IS FACTORY WARRANTED AGAINST CORROSION FOR NOT LESS THAN 5 YEARS AT NO COST TO THE

COMMONWEALTH OF PENNSYLVANIA. WARRANTY INDICATING COMPLIANCE IS REQUIRED WITH EACH VEHICLE.

2.5 Emergency warning triangle kit (on vehicles with GVWR of 10,000 lbs. or higher; aftermarket installation if necessary).

2.6 First aid kit, 10 person with mountable cabinet (on vehicles with GVWR of 10,000 lbs. or higher; aftermarket installation if necessary).

2.7 Fire extinguisher, rechargeable, with vehicle mount, reference 2A:10B:C, 5 pound (on vehicles with GVWR of

10,000 lbs. or higher; aftermarket installation if necessary).

2.8 Powerport.

2.9 Back-up alarm on all vehicles with GVWR of 10,000 lbs. or higher.

2.10 If a flexible fuel or an altenate fuel option is offered by the manufacturer, it shall be provided at no additional charge.

3.0 MATERIAL MASTERS: No Material Masters established for this delivery PCID.

Quality Assurance Specialist: Gerald Grecek

Quality Assurance Supervisor: Brian Vulgaris