Roof Replacement (Brighton)

The Housing Department of the Seminole Tribe of Florida is requesting bids from qualified contractors to provide roof replacement services needed at Brighton Reservation. ROOF REPLACEMENT: Remove and properly dispose of existing metal roofing overlay, shingles, underlayment, and associated roofing debris. Inspect all sheathing for possible damage. o If damage is found, CONTRACTOR must stop work until contact is made with the TRIBEs Project Manager to receive direction. o Pictures of damaged area must be taken. Install aluminum drip edge along all edges, eaves, and rakes per residential building code. Install leak barrier(s) at all eaves, valleys, and around penetrations. Install direct to deck underlayment over remaining wood decking. CONTRACTOR shall provide separate pricing for each of the following roofing systems, as identified in Exhibit A- Schedule of Values: o Option 1 Architectural Shingles: Furnish and install thirty (30)-year architectural roof shingles, color to be determined by the TRIBE, using oneand-one-quarter-inch (1 ) hot dipped coil nails installed in accordance with manufacturer requirement. o Option 2 Standing Seam Metal Roofing: Furnish and install 24-gauge, oneinch (1) standing seam snap-lock metal roofing panels. CONTRACTOR shall provide separate pricing for mill finish and dark green finish. o Option 3 Stone-Coated Steel Roofing: Furnish and install 26-gauge stonecoated steel barrel tile roofing in terra cotta color. Replace all existing flashing that can be accessed without damaging adjacent siding or finish materials, including counter flashing, step flashing and apron flashing, with new color coated aluminum flashing. o Step flashing must be four inches (4). o Flashing installed at masonry surfaces shall be properly cut into the masonry. o Seal all exposed nail heads, fasteners, joints, and transitions in accordance with manufacturer requirements. Furnish, install, and properly seal pipe collars at all applicable roof penetrations. Furnish and install color-matched ridge vent. Furnish and install ridge cap shingles at all hips and ridges using two-inch (2) nails, in accordance with manufacturer installation requirements. Provide separate pricing for removal and reinstallation of existing gutters. Provide separate pricing for furnishing and installation of new manufactured gutters.