Force-sensing Treadmill - Brand Name or Equal

This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in Subpart 12.6, as supplemented with additional information included in this notice. This announcement constitutes the only
solicitation; proposals are being requested and a written solicitation will not be issued.

All quotations submitted with equivalent supplies shall provide a matrix that directly point back to all MEC's.

Minimum Essential Characteristics
Brand Name or Equal
Force-sensing Treadmill
ADVANCED MECHANICAL TECHNOLOGY, INC (AMTI)
Double Belt Compact End-to-End treadmill With Incline (DBCEEWI-2)

One (1) force-sensing above-floor treadmill is required with the following characteristics:
- 30-foot power cord
- Must operate on 208 VAC, 3-phase, 20 amp Y connected power
- Must use tandem belt design with less than 2 mm clearance between the two belts
- Each belt must be at least 29 in (length) x 25 in (width)
- Each belt travel direction must be reversible for uphill and downhill movement simulation
- Must have a six-axis force plate under each belt (at least 2)
o Each force plate must:
 Measure the ground reaction forces (Fx, Fy, Fz)
 Measure the moments (Mx, My, and Mz)
 Have a range of at least 8800 N in the z direction
 Have a range of at least 4500 N in the x direction
 Linearity and Hysteresis must be at least +/- 0.2% full scale output
 Have a minimum 30-foot cable from the force plate to the signal conditioner
- Must have a signal conditioner for each force plate (at least 2)
o Each signal conditioner must:
 Have at least 6 channels
 Provide analog and digital (at least USB format) outputs
 Have BNC-5K filters for each channel
- Minimum 6.5-foot cables for each force plate must be provided (at least 2)
o These are breakout cables from the signal conditioner to the six (6) analog connectors for the force plates
- Belts must have a maximum speed of at least 20kph, adjustable in at least .06 kph increments
- Treadmill must be able to incline at least a maximum of 25% grade
- Must have removable front and side handrails
- Must have control system including:
o software with belt speed, belt travel direction, and incline adjustment
o CAN open network kit
o Hardware including workstation
o Feedback and control cables
- Must have a general maintenance kit
- Must have on-site installation and training
- Must have warranty:
o At least 5 years warranty for each of the load cells
o At least 1 year warranty for the treadmill and associated equipment
- Must include shipping to Fort Rucker, AL

1. INSTRUCTIONS FOR THE PREPARATION AND SUBMISSION OF QUOTES
Failure to submit all documents concurrently and in accordance with these instructions may render a quote unacceptable. The quote and supporting documentation shall be submitted electronically via email to Abraham Pottenger at abraham.g.pottenger.civ@mail.mil by the date and time specified on the cover page of this SF1449 Soliciation.

2. QUOTE AND SUPPORTING DOCUMENTATION EVALUATION
To aid in evaluation, quote shall be practical, specific complete, and logically assembled. The quote shall be in a clear, concise format satisfying all requirements of this solicitation. It shall be in sufficient detail to demonstrate a clear understanding of the work to be accomplished. Quotes shall be valid for at least 90 days.