Electrical Installation Work at Watson, MN

Contractor will run wiring and conduit from existing panel in office building across the office ceiling to outside of building. The contractor will trench and install electrical service from office building to inside of storage building.
- Make connection to existing electrical panel box.
- Run 1 ¼ inch conduit and electrical wire 65 feet across office ceiling to ground level outside
office building.

- Trench 150 linear feet from office building to storage building. Place 2 inch PVC pipe with 3 ea. #1 aluminum wire conductor and 1 ea. #2 neutral wire conductor in trench. Backfill trench.

- Install and wire 100 AMP breaker box inside of storage building

- Install and wire 30 AMP welder outlet, and 20 AMP GFCI outlet next to breaker box.

- Contractor will perform all work in accordance to Minnesota Electrical Codes and Standards.

- Contractor will be responsible to acquire permit and cover inspection fees.

Contractor will run wiring and conduit from existing panel in office building across the office ceiling to outside of building. The contractor will trench and install electrical service from office building to inside of storage building.

The work shall consist of but not limited to furnishing all plant, labor, material and equipment for filling the cracks in the existing asphalt pavement for approximately 1 mile of park circulation roadway and five (5) parking lots approximately 4465 square yards. Placing a one-quarter (1/4) inch thick emulsified asphaltic slurry seal coat on all designated parking lots and applying pavement markings as per existing conditions to all roadways and parking lots.