Coordinate Measuring Machines

The 76 CMXG is looking toi purchase a Coordinate Measuring Machine. 

 The software descriptions/specifications are outlined below.

• A bridge style CMM, able to measure variety of parts to an accuracy of 1.5 + L/333 microns or better. Length measuring uncertainties guaranteed from 18 - 22°C.

• Minimum table measurement range of x=500mm, y=700mm, z=500mm.

• Reference/Probe Qualification sphere.

• Automatic Stylus Changer.

• Stylus Kit with multiple probes from 3mm diameter to 8 mm diameter.

• Option to add optical sensors.

• 2.5 degree articulating head

• Scanning Probe

• Option to add optical sensors.

• Ability to program directly from CAD models

• Ability to create parametric programs

• Jog Box with single joystick or an operator panel with dual joysticks

• Air Dryer/Oil removal that supports a minimum of 10 CFM.

• Total footprint allocated for the installation of the CMM shall not exceed 72" by 72".

• Room ceiling height is 102 inches. The ceiling is a drop ceiling, but the Government does not wish to raise the ceiling to accommodate a new CMM. However, if required, the Government will raise the ceiling tile directly over the final placement of the CMM. The ceiling tile directly over the CMM can be raised a height of 18" for a total ceiling height of 120". The access doorway for the room is 71 inches wide by 83 inches tall.

• System shall operate on 120 VAC, 1 phase, 60 hertz with amperage not to exceed 20 amps.

• Low pressure air at 150 psig not to exceed 20 cfm.

• The contractor shall deliver and perform on-site installation of the CMM at 3538 C. Avenue, Tinker AFB, OK 73145 in Building 200, Room 118. The contractor will supply all transportation, rigging, forklift/crane, and labor necessary for offloading, transport and installation at permanent location.

Operator Training for a minimum of 2 attendees (may be onsite, online or at contractor’s facility or combination thereof).

• Basic training - basic understanding of software and measurement capabilities of CMM and operating CMM for first time users.

• Advanced training - cover advance concepts beyond the basic training, such as importing CAD files for parts measurement, learning scanning concepts for analog scanning probes.

• Contractor must meet all requirements outlined in the Statement of Work (SOW).