Building 66048 at Kirtland AFB

"This action was awarded as an 8(a) Sole Source Set-Aside under the authority of section 8(a) of the Small Business Act."
The contractor shall furnish all parts, material, labor, equipment and supervision necessary to complete the work for Building 66048 Repair RDS Front Office.
a.Demolition
1.Demo all carpet in corridor 121D and 121C as shown on the drawings.
2.Remove existing door assembly from room 138 and salvage for reinstallation.
3.Demo wall assembly in its entirety around room 138 as shown on the drawings.
4.Remove all electrical, communication, and LAN receptacles, boxes, outlets, wires, switches and conduits from demolished wall as shown on the drawing. Pull wires back to nearest junction box if not needed. Coil unused communication and LAN cables above the ceiling grid.
5.Demo ceiling grid and tiles as needed to remove wall as shown on the drawings. Prep ceiling for new work.
6.Demo wall for new door into room 135 as shown on the drawings.

b.Construction
1.Install new carpet tiles in areas as shown on the drawings. Provide transition strips for all doorways and termination points as needed.
2.Install new wall base as shown on the drawings. Match existing.
3.Repair all walls in the work area as needed.
4.Paint all walls as shown on the drawings.
5.Install or repair the ceiling grid and replace ceiling tiles as shown on the drawings.
6.Relocate switch and/or rewire light fixtures in room 138.
7.Relocate and rewire light switches for corridor lights as shown on the drawings.
8.Install two new storefront door assemblies as shown on the drawings.
9.Install new rough-in boxes and conduits to support card reader access as shown on the drawings.
10.Construct new wall in room135 as shown on the drawings.
11.Reinstall existing door, frame, and hardware at the new room created in room 135 as shown on the drawings.