RFI 001 Answered.pdf

RFI Date

1.

9/10/20

2.

9/10/20

3.

9/10/20

4.

9/10/20

-s-.

'6-.

9/10/20

9/10/20

'8,, '9-.

7 9/10/20

1{l.

8 9/10/20

--:1:--L

9 9/10/20

12.

9/14/2020

SOLICITATION: W912L8-20-B-0008-P00001

JOB TITLE: USPFO Door Replacements USPFO for WV, Buckhannon, WV 26201

Requests for Information - Questions and Answers

Question Answer

At rront entry oraw1ng, concrete 1s oniy to oe removeµ to the brick face. The remaining slab is cracked and Remove existing concrete to nearest out of level so it also needs demo'ed and control joints.

replaced.

The new doors, same drawing, are shown to line up The new aluminum doors and frame with the brick face. The new frame and doors need to be held back behind the steel at the head of the can be held back from the edge brick.

opening 2-3" and keypad will need to be relocated.

Door Hardware - the storefront and blast HM Supplie s Provide as required to meet blast may have blast tested with a specific hardware which would need to be used in lieu of the hardware standards specified.

t::xtenor HM tllast uoor - orawn as a s1ng1e ooor w1tn

Proceed with installation of double hollo\11 a sidelite. This needs to be a pair to allow moving larger items per Maintenance Supervisor on site. metal doors. One door to have only Floor plan shows single, next drawing shows a pair Flush Bolts top and bottom �, 'J �rn- h .. l n� • : ... ,.. ,.J - Could these be blast storefront since C drawing indicates full glass?

All l:i1ass t::mrances - ;:,mce v1srawa11 was purcnasec by Oldcastle making only 2 manufacturers. Could CF CR Laurence Hurculite is an acceptable Laurence Hurculite Glass Doors be considered as ar equal equal? (See Attached)

I"" l:ilass cn,rances - 1 nis prouuc, wou1a require Provide gypsum board wall from existing building a wall from the bar joists down to the suspended ceiling. Could we jut use a pair of Mediu1 n metal joists to head of new aluminum Stile Aluminum Doors with Transom that would not frame. All door hardware suggestions

1 .-on1 iir-o h1 ,:i-1:-- ,::i, .. �11 u.,hi .... h u.,n, ilrl n,-nh,::i,hh -reduce the cost by 1/3 of the All Glass Entrance.

die dll a1.,1...c:JJLdUle. \....lldll\::Je IIILCI IVI \::Jld::,::, The all Glass Entrance would require a 1 O" bottom entrance door to a double set of 3'-0" X rail to meet ADA. Hardware should be push/pull 7'-0" doors.

and closers.

titorerront ::;pees state tllacK anoo1zeo finish.

Existing doors and windows are dark bronze Proceed with dark bronze anodized anodized. Please advise.

::;mce tne intent 1s to install erectnc panics 1n me Proceed with providing EL Panics, ept future, shouldn't we change the hardware to EL

10 power transfers with shielded wire Panics and add ept 10 power transfers with shielded wire to the door head and a power supply to door head and power supplies.

-· :M ~n n

Schlage primus keycores are specified. Existing Install Schlage Primus cores keying is Dorma. Should we provide a high security Dorma Key cylinder instead?