Updated Spec - Passenger Van - Montenegro (003).doc

Specification August 2020

VAN, PASSENGER

THE VEHICLE SHALL BE PROVIDED WITH ALL NEW PARTS, THE MANUFACTURER’S STANDARD EQUIPMENT, AND THE FOLLOWING MINIMUM EQUIPMENT AND CAPABILITIES:

1. CONFIGURATION

1.1. The vehicle shall be a Passenger Van with seating for driver, one front passenger, and second row seating for three additional passengers.

1.1.1. The second row seating shall be removable.

1.2. No partition shall be provided.

1.3. The cargo area with the second row seating removed, shall have at least a 144.8 cubic feet (4.1 cubic meters) load area volume.

1.4. The vehicle door configuration shall be as follows:

1.4.1. Two front, hinged doors

1.4.2. At least one side sliding door

1.4.3. Split, hinged rear doors with a pull out ramp

1.5. The vehicle shall be a 2019 model year or later, with at most 300 miles (483 km) on the odometer.

1.6. Manuals shall be provided, written in English and Serbian, including:

1.6.1. An Owner’s manual

1.6.2. A Service manual

1.6.3. A Parts manual

2. SAFETY

2.1. The vehicle shall meet all applicable Economic Commission for Europe (ECE) and European Economic Community (EEC) safety standards.

2.2. The vehicle shall meet all DOT requirements of Montenegro.

3. EQUIPMENT

3.1. The vehicle shall be equipped with all the standard equipment including:

3.1.1. Air conditioning

3.1.2. Antilock Brakes System (ABS)

3.2. The vehicle instrument gauges shall be in Metric units.

3.3. An ABC type fire extinguisher, minimum 2.2 lb (1.0 kg) capacity, with mounting bracket shall be provided.

3.4. All vehicle windows behind the front seats shall be tinted to the darkest that European standards will allow.

3.5. The vehicle shall be equipped with a Motorola MTM5400 TETRA mobile radio with integrated GPS mounted near the front passenger seat.

3.5.1.

Antenna(s) must be supplied and mounted on the vehicle and compatible with frequency ranges UHF 388 - 430 MHz.

3.6. The vehicle cargo area shall be equipped with the following:

3.6.1. Non-locking cabinets with at least .135 cubic meter (4.76 cubic foot) of storage

3.6.2. Shelves with at least .270 cubic meter (9.53 cubic foot) of storage

3.6.3. Cabinets and shelving shall be constructed of sheet metal

3.6.4. At least (5) Hooks to hang gear and clothing

3.6.5. All cabinets, shelving, and hooks shall be against the side walls in the cargo area so as not to block the rear windows. It is acceptable to partially or fully block any side cargo area windows.

3.6.6. At least (1) 110V/60Hz and (1) 220V/50Hz electrical outlets shall be provided that are wired to run off the vehicle’s battery(ies)

3.6.6.1. The 110V outlet should be powered with at least 1000 watts of continuous and 2000 watts of peak power.

3.6.6.2. The 220V outlet should be powered with at least 1500 watts continuous and 3000 watts of peak power.

3.7. The vehicle shall be equipped with a full-size spare with tire changing tools including:

3.7.1. A lifting jack

3.7.2. A lug wrench

4. ENGINE

4.1. The vehicle shall be equipped with at least a diesel Euro 5 engine, able to operate long-term on fuel available Montenegro.

5. STEERING

5.1. The vehicle shall be left hand drive (LHD).

6. TRANSMISSION

6.1. The vehicle shall be provided with manual transmission.

7. EMERGENCY VEHICLE LIGHTING SYSTEM

7.1. The vehicle shall be provided with Emergency Vehicle Lighting System including:

7.1.1. Permanent roof mounted light bar – blue color

7.1.1.1. Blue light(s) shall be LEDs

7.1.2. Siren

7.1.2.1. At least 100 watts

7.1.2.2. Siren sound must meet European Standard.

8. EXTERIOR COLOR

8.1. The exterior color of the vehicle shall be Olive Drab.

9. RADIO FREQUENCY IDENTIFICATION (RFID) TAGS

9.1. Each vehicle or item and associated lot of spares shall be tagged with a removable active RFID data rich tracking tag, specifically designated as:

9.1.1. Savi ST-654-041

9.1.2. Savi ST-654-031

9.1.3. Identec I-Q310 DRT

9.1.4. Evigia EV3-DRT

9.2. The tag shall be located on the exterior of the vehicle or item in a noticeable and easily observable spot. The tag for the spares shall be located in a noticeable and easily observable spot on the exterior of the pallet or container.

9.3. The tag shall be securely affixed to the vehicle or item in such a way that it cannot fall off. Securing the RFID tag with two or more plastic cable ties is the preferred method.

9.4. The tag data and electronic data field format shall be in accordance with specifications established by Joint Total Asset Visibility (JTAV) version 2.0, section 3.4.1 "Commodity Item Database Format" with the following clarifications:

9.4.1. The "document field" titled "DOCUMENT" shall be the document number (e.g. “milstrip”) as specified by the Government procuring agency.

9.4.2. The "MISC1" field shall be the item serial number, if available.

9.4.3. The "MISC2" field shall be used for user comments (e.g. contract number).