Bldg 143 Radiant Heat Renovations.pdf

NOT TO SCALE

RADIANT HEATER - TYPICAL ASSEMBLY

NOT TO SCALE

RADIANT HEATER - TYPICAL BURNER

18"

BIRDSCREEN TO BE

PLACED AT END OF

DISCHARGE

NOTE:

1. ALL C-PVC AND PVC PIPE, ELBOWS, AND

COUPLERS BY PLUMBING CONTRACTOR.

MOUNTING

BRACKETS

FOR

VACUUM

PUMP

CONDENSATE

PUMP

P.V.C. LINE TO RUN AS SHOWN ON

PLUMBING PLANS.

NOT TO SCALE

VACUUM PUMP VENT DETAIL

12"

2"

1. GAS PIPE WORK MUST BE INSTALLED AND TESTED IN ACCORDANCE WITH

UNITED STATES ANSI Z 223.1/NFPA 54 LATEST ADDITION AND NADA-CSA-B149.1

2. INSTALL THE FLEX GAS CONNECTOR AS SHOWN. THE FLEX GAS CONNECTOR

ACCOMMODATES EXPANSION OF THE HEATING SYSTEM AND ALLOWS FOR

EASY INSTALLATION AND SERVICE OF THE BURNER.

3. SHUT-OFF VALVE MUST BE PARALLEL TO BURNER INLET. THE 2" DISPLACEMENT

SHOWN IS FOR THE COLD CONDITION. THIS DISPLACEMENT MAY REDUCE WHEN THE

SYSTEM IS FIRED.

BLUE WIRE TO TRANSFORMER

PURPLE WIRE TO VALVE CONTROL

1. IN ORDER TO USE LINE VOLTAGE THERMOSTATS, THE INTERNAL JUMPER

CONNECTION LOCATED AT THE THERMOSTAT CONNECTIONS INSIDE OF EACH BURNER

MUST BE CONNECTED TO THE BLUE AND PURPLE WIRES AS SHOWN.

2. HEATERS MUST BE GROUNDED IN ACCORDANCE WITH APPLICABLE CODES: UNITED

STATES: REFER TO NATIONAL ELECTRICAL CODE® ANSI/NFPA-70 LATEST VERSION.

HOLD GAS NIPPLE SECURELY

WITH PIPE WRENCH WHEN

ATTACHING THE FLEX GAS

CONNECTOR.

FAILURE TO FOLLOW THESE

INSTRUCTIONS WILL RESULT IN

PROPERTY DAMAGE.

ELECTRICAL SHOCK HAZARD

DISCONNECT ELECTRICAL POWER BEFORE

SERVICING.

REPLACE DOOR BEFORE OPERATING.

FAILURE TO FOLLOW THESE INSTRUCTIONS

WILL RESULT IN DEATH OR ELECTRICAL SHOCK.

NOTES:

NOT TO SCALE

IRH DETAIL - GAS CONNECTION

NOT TO SCALE

IRH DETAIL - LINE VOLTAGE

THERMOSTAT WIRING

NOT TO SCALE

TYPICAL HANGER ATTACHMENTS