Atch_01,_PWS,_NG-0018-19.pdf

USATA-NG-0018-19

Attachment 01

PERFORMANCE WORK STATEMENT

TO REPLACE JLS M142S MOTOR CALIBRATOR

1.0 GENERAL. The U.S. Army Test, Measurement and Diagnostic Equipment Activity (USATA) located at Redstone Arsenal, Alabama has a requirement to replace one (1) each JLS Model 142S Motor Calibrator. The calibration system shall be delivered to USATA’s Radiation Standards Laboratories (RSL) located at Building 5435, Fowler Road, Redstone Arsenal. The system will be used in the U.S. Army Radiation Standards Laboratory (RSL) to support Army medical and Army fields operations.

2.0 GOVERNMENT TASKS.

The U.S. Army TMDE Activity, Redstone Arsenal, AL (Acceptance DODAAC: W80RA6) shall be responsible for receiving, inspection and acceptance in DFAS Wide Area Workflow (WAWF) for all units.

3.0 CONTRACTOR TASKS.

3.1 The contractor shall deliver the JLS Model 142S Motor Calibrator to USATA’s RSL located at Building 5435 Fowler Road, Redstone Arsenal, AL. 35898. The contractor shall install the hardware in accordance with original equipment manufacturer specifications.

3.2 The contractor shall conduct one day installation and setup of the new equipment. The setup should take place between the hours of 0800-1700. The contractor shall provide operation manuals and technical data rights for complete maintenance and troubleshooting of the systems.

3.3 The Contractor shall furnish all labor, material and equipment required to install the system and provide calibration in accordance with the manufacturer’s specifications.

3.4 The Contractor shall not provide repair or other services outside the scope of this contract without authorization from the government Contracting Officer.

4.0 PLACE OF PERFORMANCE. Performance shall take place at the Government’s facility as follows:

U.S Army TMDE Army Primary Standards Lab Building 5435 Fowler Rd.

Redstone Arsenal, AL 35898

5.0 PERIOD OF PERFORMANCE. In accordance with Section B of the contract.

6.0 GOVERNMENT-FURNISHED EQUIPMENT. None.

7.0 QUALITY REQUIREMENTS. Not Applicable.

8.0 CONTRACTOR MANPOWER REPORTING REQUIREMENT – SERVICE CONTRACTS.

USATA-NG-0018-19

Attachment 01

8.1 Department of the Army requires reporting of all contractor labor hours associated with services, to include calibration and repair, provided to United States Army organizations;

therefore,

8.2 The contractor shall report ALL contractor labor hours (including subcontractor labor hours) required for performance of services provided under this contractor for the U.S. Army TMDE Activity via secure data collection site. The contractor is required to completely fill in all required data fields using the following web address: https://cmra.army.mil, and then click on “Department of the Army CMRA” or the icon of the DOD organization that is receiving or benefiting from the contracted services.

8.3 Reporting inputs will be for the labor executed during the period of performance during each Government fiscal year (FY), which runs October 1 through September 30. While inputs may be reported any time during the FY, all data shall be reported no later than October 31 of each calendar year, beginning with 2015. Contractors may direct questions to the help desk by clicking on “Send an email” which is located under the Help Resources ribbon on the right side of the login page of the applicable Service/Component’s CMR website.

https://cmra.army.mil/