Machined MTS Parts Attachment 3 4.pdf

18”

26.5”

Our MTS machine’s maximum dimensions

Axial Testing

To be used for compressing specimens – surface contacting specimens should be low-friction

Stainless steel block with low-friction plastic or other material on the bottom to allow specimen motion (attach to MTS machine directly)

Rotating head bench vise to hold specimens (to be purchased)

50-lb capacity cross-slide table (to be purchased)

Stage

Torsion

NEED TWO OF THESE:

Small: 4” inner diameter pot Large: 8” inner diameter pot

NEED TWO OF THESE:

Small: 2.25” inner diameter pot Large: 4” inner diameter pot

U-Joint

U-Joint

Three/Four Point Bend Setups

T slotted for adjustability, include hash marks

T slotted for adjustability, include hash marks Same base plate as axial testing

-Setup should be large enough to fit long bone specimens -Include mechanism for securing bones in place during testing on rollers

NO NEW PARTS, shown to demonstrate adaptability of bend setup

One roller can come off to enable 3 point bending

Cantilever Bend

Roller contoured to fit 2.25” outer diameter tubing

Rotating specimen holder (rotates to ensure specimen perpendicular to load)

Extended stage with T-slots for adjustability

Also need 2x parts of same radius with detachable bottom for potting