R11ChangePage208May2013.pdf

MIL-PRF-32080E Change Page 2 08 May 2013

1. Paragraph 3.10.14 shall now read as follows:

“3.10.14 Deadman control system (DCS). A deadman device shall be provided as part of the DCS and shall be (1) air operated, and (2) used to initiate or terminate the flow of fuel in all fueling modes at the single-point and overwing hose reels, hydrant pit outlet, and at the emergency tank valve when activating or deactivating the deadman device.

Deactivating the deadman device shall reduce engine speed to idle. After reactivation of the deadman device, the flow shall resume within 15 seconds. The deadman device shall be operable while wearing arctic mittens and MOPP Level 4 Chemical Warfare Gear and shall allow the operator to range from the operator control panel to the full length of the servicing hose(s). A momentary-on push button for rewinding the deadman hose reel shall be provided and shall be conveniently located on the operator control panel such that the operator can guide the deadman hose with one hand while operating the rewind control button with the other hand. It shall be capable of retracting the fully deployed deadman hose and device within one minute. The deadman hose shall have a minimum length of 80 feet. A fairlead shall guide the hose during deployment or rewind.”

2. In paragraph 3.10.1 Piping. The following sentence "Piping shall be not less than schedule 40 seamed or seamless aluminum in accordance with ASTM B241/B241M or schedule 10 stainless steel and shall disassemble in sections.”

Shall be changed as follows:

“The piping shall be seamless schedule 40 aluminum in accordance with ASTM B241/B241M or seamless schedule 10 TP 304L stainless steel in accordance with ASTM A312/A312M.”