Sheetmetal_Trailer_Item_Specifications.pdf

DEPARTMENT OF THE AIR FORCE

OKLAHOMA CITY AIR LOGISTICS COMPLEX (OC-ALC)

TINKER AIR FORCE BASE OKLAHOMA

Item Specifications

B-52 SHEET METAL TRAILER

76TH AMXG requests the purchase of One (1) each B-52 Sheet Metal Trailer meeting the following criteria:

1.1. The trailer shall be a 7,000 lb. minimum tandem axle that is 7’ wide by 18’ length.

1.2. Trailer must have a minimum 7' interior height.

1.3. Trailer shall have ST175/80R13 LR “C” Goodyear Radial or equivalent tires that are sufficient for towing trailer behind a motorized vehicle.

1.4. The trailer shall be equipped with a 2,000 lb. top crank A-frame or equivalent tow bar with a pintle ring.

1.5. The trailer shall be equipped with a storage box that is 69” length x 20” width x 15” deep mounted on tongue of trailer.

1.6. The insulated entry door shall be 36” wide with right hand hinge and be located on the right hand side (curbside), approx. 30" from front (tow end) of the trailer. Door will open outwards.

1.7. The entry door shall be equipped with a cypher lock door handle.

1.8. The door entry way shall be equipped with a foldable door step.

1.9. One window that is 3 feet wide by 3 feet height shall be installed. The window shall be located on the left hand side (curb side) of the trailer at the front end. Window will be non-opening, tinted, and of sealed exterior/flush mount type.

1.10. The trailer shall be equipped with a rear drop down ramp that is the width and height of the trailer. Ramp shall be equipped with latches that can be padlocked for security.

1.11. The ramp should be lined with a textured surface of rubber or similar high grip compound. Ramp and lining have to be durable enough to withstand routine traffic from wheeled toolboxes.

1.12. Flooring shall be heavy duty non-skid vinyl flooring or similar material.

1.13. Trailer shall be equipped with an insulated vinyl ceiling liner. Sidewall insulation shall be a minimum of 1 inch R5 fiberglass insulation.

1.14. The countertop will be L-shaped and located all the way across the front end of the trailer and down the left side (road side) 8 feet from front wall. Countertop shall be 28" high and the depth shall be 25”. The countertop shall have cable drops located in the corners and one in middle of left hand side counter for a total of four holes for computer/printer cables. Contractor should check with 76AMXG/QPE for color specifications.

1.15. The trailer shall have overhead LED lighting to provide visibility inside the trailer.

1.16. In place of the standard overhead AC/Heat unit the trailer shall be equipped with an 18,000 BTU AC/Heater (Window Style Unit) in the front (tow side) wall over the trailer tongue and centered side to side but mounted closer to the roof to allow for shelving underneath.

1.17. The trailer shall be equipped with a 100 AMP Service Panel (120/240 Volt) and wired for 230 VAC.

The 3rd hot leg from the Power Receptacle (1.19) should be routed to and capped off in the trailer circuit breaker box if necessary. Service panel will be located on left wall near power receptacle.

1.18. One large hook shall be mounted on the outside of the trailer on the left side (road side) close to front of trailer for power cord storage.

1.19. The trailer mounted power receptacle shall be equivalent to the Hubbell HBL3521C connections, but be water/weather proof and match end of power cord (1.20). Receptacle will be located on left side of trailer, approximately 18" from front wall and approximately 12" above the internal flooring.

1.20. The Power Cord shall be a 50 feet power cord with plug equivalent to Hubbell HBL3521C or equivalent at one end and 20A/250V water/weather proof plug on opposite end that matches the receptacle on trailer (1.19). There shall be a power cord provided for each trailer.

1.21. Electrical Outlets – Approximate location:

A. One 110 vac duplex wall receptacle on right side (curbside) centered between door and ramp, 18" high.

B. One 110 vac duplex wall receptacle on front wall above counter.

C. Four 110 vac duplex wall receptacles on left side (road side), above counter. Aft receptacle shall be 4feet from back wall, middle receptacles 8 feet and 12 feet from back wall, and forward receptacle shall be 2 feet from front wall.

D. Receptacle for 18,000 BTU AC/Heater (Window Unit Style) on front wall near air conditioner

1.22. The trailer shall be equipped with adjustable heavy duty rear corner post jacks and 24 inch front Scissor jacks.

1.23. Install pegboard on front and left hand blank walls.