ITEM_005.docx

ATTATCHMENT B

SPECIFICATIONS/REQUIREMENTS

1. The contractor shall furnish ammunition on an order in accordance with specifications shown below.

1. CLIN 0001, AU74 AMMUNITION, “260 REM 130gr Long Range Match “

2a. BULLET: 6.5mm 130 Berger Hybrid .264 dia. 130gr Berger Hybrid projectile is first option. Or any higher BC 6.5mm projectiles- higher than .291 G7 that meets accuracy standards and is 2650Fps MV. Bullet cannot exceed 135gr in weight.

2b. BRASS: 260 REM best option

2c. PRIMER: STD Large Rifle Match

2d. POWDER: vendor option any propellant that meets safe reliable function of ammunition.

2e. CARTRIDGE LENGTH: Max 2.830 OAL intent is Magazine length for Bolt Action short actions. Or .308 AR platforms.

2f. MUZZLE VELOCITY: ammunition must produce a minimum of 2650+FPS no less than 2620fps at 10 ft from muzzle at ambient temps, from 18" Bolt Action Match barrels.

2g. ACCURACY STANDARDS- Rifle 18” barrel: Ammunition must average 2.25 inches (.71 MOA) or less at 300 yards when fired from 2ea USAMU Bolt Action Test Barrels. 5 each 10 rd groups.

2h. LOT INFO: Lot size shall be no smaller than 5,000 cartridges. Largest lot sizes are preferred. The cartridges shall be New Manufacture ammunition no used components. The assembled ammunition must be in identifiable lots. Each lot shall consist of units of product of a single type, grade, class, size and composition, manufactured under the same conditions, by the same manufacturer, and at the same time. Only one type and weight of propellant shall be used in a lot of cartridges. Each cartridge lot shall contain no more than one lot of primers, one lot of propellant, one lot of projectiles.

2i. FUNCTIONAL CHARACTERISTICS: Ammunition must cycle reliably from std 18” Short action bolt rifles or AR style rifles. There shall be no weapon stoppages due to the cartridges. No failures to extract, no hang fires, no misfires either from primer failure or no vent hole in cartridge. No projectiles shall remain in the bore. There shall be no gas leakage or primer failures due to perforation of primer during firing pin indent, escape of gas through primer cup or around primer cup, no loose primers or blown primers. There shall be no cartridge case casualties due to longitudinal split at any point on case mouth, body, or head. There shall be no cartridge case casualties due to circumferential rupture at any point on cartridge case mouth, body, or head.

3. Vendor will provide component information Vendor Technical Data Sheet for each CLIN of ammunition.