ITEM_003.docx

ATTATCHMENT B

SPECIFICATIONS/REQUIREMENTS

1. The contractor shall furnish ammunition on an ordered in accordance with specifications shown below.

1. CLIN 0001, AU72 AMMUNITION, “215gr 300 WIN MAG Long Range Match “

2a. BULLET: 215gr Berger .308 dia. is first option. Or any higher BC .308 projectiles- higher than .354 G7 that meets accuracy standards and is min 2875+/- 20FPS MV. Bullet weight cannot exceed 215.7grs.

2b. BRASS: Match Quality similar to Lapua.

2c. PRIMER: 215M or 210M Large Rifle Match or better

2d. POWDER: vendor option any propellant that meets safe reliable function of ammunition.

2e. CARTRIDGE LENGTH: Max 3.354 OAL. OAL is also vendor option-intent is Magazine length for Bolt Action Long action rifles.

2f. MUZZLE VELOCITY: ammunition must produce a minimum of 2875Fps for 215gr ammunition. All measured 10 ft from muzzle at ambient (70F) temps, from 27" Bolt Action Match barrels.

2g. ACCURACY STANDARDS- Rifle 27” barrel: Ammunition must average 1.75 inches (.55 MOA) or less at 300 yards when fired from 2 ea USAMU Bolt Action Test Barrels. 5 each 10 rd groups.

2h. LOT INFO: Lot size shall be no smaller than 3,000 cartridges. Largest lot sizes are preferred. The cartridges shall be New Manufacture ammunition no used components. The assembled ammunition must be in identifiable lots. Each lot shall consist of units of product of a single type, grade, class, size and composition, manufactured under the same conditions, by the same manufacturer, and at the same time. Only one type and weight of propellant shall be used in a lot of cartridges. Each cartridge lot shall contain no more than one lot of primers, one lot of propellant, one lot of projectiles.

2i. FUNCTIONAL CHARACTERISTICS: Ammunition must cycle reliably from std 27” Bolt Long action rifles. There shall be no weapon stoppages due to the cartridges. No failures to extract, no hang fires, no misfires either from primer failure or no vent hole in cartridge. No projectiles shall remain in the bore. There shall be no gas leakage or primer failures due to perforation of primer during firing pin indent, escape of gas through primer cup or around primer cup, no loose primers or blown primers. There shall be no cartridge case casualties due to longitudinal split at any point on case mouth, body, or head. There shall be no cartridge case casualties due to circumferential rupture at any point on cartridge case mouth, body, or head.

3. Vendor will provide component information Vendor Technical Data Sheet for each CLIN of ammunition