iTEM_001.docx

ATTATCHMENT B

SPECIFICATIONS/REQUIREMENTS

1. The contractor shall furnish ammunition on an ordered in accordance with specifications shown below.

1. CLIN 0001, AU70 AMMUNITION, “155gr .308 Palma Match “

2a. BULLET: 155gr Sierra .308 dia. Pro#2156 Match King projectile is first option. Or any higher BC .308 projectiles- higher than .504 G1 that meets accuracy standards and is 3000Fps MV. Bullet weight cannot exceed 155grs.

2b. BASS: Match Quality similar to Lapua.

2c. PRIMER: STD Large Rifle Match

2d. POWDER: vendor option any propellant that meets safe reliable function of ammunition.

2e. CARTRIDGE LENGTH: Max 2.925 OAL intent is single loaded ammunition for short action rifles Palma style rifles.

2f. MUZZLE VELOCITY: ammunition must produce a minimum of 3000+FPS no less than 2985fps at 10 ft from muzzle at ambient (70F) temps, from 30" Bolt Action Match barrels.

2g. ACCURACY STANDARDS- Rifle 30” barrel: Ammunition must average 1.75 inches (MOA) or less at 300 yards when fired from 2ea USAMU Bolt Action Test Barrels. 5 each 10 rd groups.

2h. LOT INFO: Lot size shall be no smaller than 8,000 cartridges. Largest lot sizes are preferred. The cartridges shall be New Manufacture ammunition no used components. The assembled ammunition must be in identifiable lots. Each lot shall consist of units of product of a single type, grade, class, size and composition, manufactured under the same conditions, by the same manufacturer, and at the same time. Only one type and weight of propellant shall be used in a lot of cartridges. Each cartridge lot shall contain no more than one lot of primers, one lot of propellant, one lot of projectiles.

2i. FUNCTIONAL CHARACTERISTICS: Ammunition must cycle reliably from std 30” Bolt short action rifles. There shall be no weapon stoppages due to the cartridges. No failures to extract, no hang fires, no misfires either from primer failure or no vent hole in cartridge. No projectiles shall remain in the bore. There shall be no gas leakage or primer failures due to perforation of primer during firing pin indent, escape of gas through primer cup or around primer cup, no loose primers or blown primers. There shall be no cartridge case casualties due to longitudinal split at any point on case mouth, body, or head. There shall be no cartridge case casualties due to circumferential rupture at any point on cartridge case mouth, body, or head.

3. Vendor will provide component information Vendor Technical Data Sheet for each CLIN of ammunition.