ITEM_002.docx

ATTATCHMENT B

SPECIFICATIONS/REQUIREMENTS

1. The contractor shall furnish ammunition on an ordered in accordance with specifications shown below.

1. CLIN 0001, AU69 AMMUNITION, “175-178gr .308 Long Range Match “

2a. BULLET: 175gr Sierra TMK .308 dia. 175gr Sierra Tipped Match King projectile is first option. Or any higher BC .308 projectiles- higher than .575 G1 that meets accuracy standards and is 2750Fps MV. Bullet weight cannot exceed 178grs.

2b. BRASS: Match Quality similar to Lapua.

2c. PRIMER: STD Large Rifle Match

2d. POWDER: Vendor option any propellant that meets safe reliable function of ammunition.

2e. CARTRIDGE LENGTH: Max 2.835 OAL intent is Magazine length for Bolt Action short action rifles.

2f. MUZZLE VELOCITY: Ammunition must produce a minimum of 2750+FPS no less than 2725fps at 10 ft from muzzle at ambient (70F) temps, from 26" Bolt Action Match barrels.

2g. ACCURACY STANDARDS- Rifle 26” barrel: Ammunition must average 1.75 inches (MOA) or less at 300 yards when fired from 2ea USAMU Bolt Action Test Barrels. 5 each 10 rd groups.

2h. LOT INFO: Lot size shall be no smaller than 5,000 cartridges. Largest lot sizes are preferred. The cartridges shall be New Manufacture ammunition no used components. The assembled ammunition must be in identifiable lots. Each lot shall consist of units of product of a single type, grade, class, size and composition, manufactured under the same conditions, by the same manufacturer, and at the same time. Only one type and weight of propellant shall be used in a lot of cartridges. Each cartridge lot shall contain no more than one lot of primers, one lot of propellant, one lot of projectiles.

2i. FUNCTIONAL CHARACTERISTICS: Ammunition must cycle reliably from std 26” Bolt short action rifles. There shall be no weapon stoppages due to the cartridges. No failures to extract, no hang fires, no misfires either from primer failure or no vent hole in cartridge. No projectiles shall remain in the bore. There shall be no gas leakage or primer failures due to perforation of primer during firing pin indent, escape of gas through primer cup or around primer cup, no loose primers or blown primers. There shall be no cartridge case casualties due to longitudinal split at any point on case mouth, body, or head. There shall be no cartridge case casualties due to circumferential rupture at any point on cartridge case mouth, body, or head.

3. Vendor will provide component information Vendor Technical Data Sheet for each CLIN of ammunition.