Aquaphalt_-_SDS__1_.pdf
PDF 136 KB Posted
- Attached to
- Competitive Selection OH|DOT10226-6
- Contract number
- DOT10226-6
- Issued by
- Ohio
About this file
This document is a Safety Data Sheet (SDS) for Aquaphalt, a cold asphalt mix product manufactured by RoadStone Production, LLC, located in Charlottesville, Virginia. The SDS was revised in March 2020 and provides comprehensive safety information about the Aquaphalt product line, which includes variants 0/4.0, 0/6.0, 0/9.0, and 0/12.0. The document is prepared in compliance with OSHA hazard communication standards and provides detailed information for safe handling, storage, and use of the product.
The Aquaphalt product is a reactively curing, cold-applied asphalt mix without solvents, composed of 92-94% mineral aggregates and 8-6% binder. It is primarily intended for patching asphalt and concrete surfaces. The product is classified as non-hazardous, with minimal health and fire risks (NFPA 704 rating of Health-0, Fire-0, Reactivity-1). The SDS indicates that the product is not regulated for shipping by US DOT and all ingredients are either on the inventory or exempt from listing under the Toxic Substances Control Act (TSCA). The document provides detailed guidance on first aid, fire-fighting measures, accidental release procedures, handling, storage, exposure controls, and personal protection recommendations.
View the file
Other files
Show all 39
On GovTribe
Work with this file
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
RoadStone Production, LLC 1230 River Road, Charlottesville, VA 22901, Tel: 866-784-5031 www.aquaphalt.com
Aquaphalt Safety Data Sheet
SECTION 1: PRODUCT AND COMPANY INFORMATION
GHS product identifier: Cold Asphalt Mix Trade Name: Aquaphalt Premium 0/4.0, 0/6.0, 0/9.0, 0/12.0 Recommended use: Reactively curing, cold applied asphalt mix, free of solvents Emergency phone number
EMERGENCY CONTACT 24 hours:
CHEMTREC 1-800-424-9300
INFORMATION CONTACT: 866-784-5031
Manufacturer
RoadStone Production LLC 1230 River Road
Charlottesville, VA 22901
Revision Issue Date: March, 2020 Supersedes Date: January, 2015
SECTION 2: HAZARDS IDENTIFICATION
Signal Word: Warning
Physical Hazards: Not Classified
Health Hazards: The product is classified as not acute toxic, not sub-acute respectively chronically toxic, and classified as not irritating or sensitizing. Causes mild/moderate eye irritation (tears, blurred vision and redness), prolonged exposure may cause moderate skin irritation. May cause drying/defatting of the skin. Not likely to be toxic if ingested, but may cause irritation of the mouth, throat and stomach. See Section 11 for more information
Pictogram: Not Applicable Precautionary Statements:
Environmental Hazards: Not Classified
R O A D S T O N E
PRODUCTION LLC
Version March 2020 Page 2 of 5 Safety Data Sheet AQUAPHALT 0/4.0, 0/6.0, 0/9.0, 0/12.0, AQUAPHALT SAFETY DATA SHEET, Rev. Date: Mar 2020Page 2 of 5
Chemical family: _Bitumen Asphalt without Solvent_
This product does not contain any carcinogens or potential carcinogens as listed by OSHA, IARC or NTP.
While this material is not considered hazardous by the OSHA Hazard Communication Standard (29 CFR 1910.1200), this MSDS contains valuable information critical to the safe handling and proper use of the product. This MSDS should be retained and available for employees and other users of this product.
Potential Environmental Effects: See Section 12 for more information
SECTION 3: COMPOSITION, INFORMATION ON INGREDIENTS
Component CAS # % by Wt.
Mineral aggregates _not applicable_ 92 - 94 Binder _not applicable_ 8 - 6
HAZARDS DISCLOSURE: This product contains no known hazardous materials as defined by the OSHA
Hazard Communication Standard 29 CFR 1910.1200.
SECTION 4: FIRST AID MEASURES
Eye contact: Rinse opened eye for several minutes under running water; consult a physician.
Skin contact: Remove contaminated clothing and wash before reuse. Wash skin with soap and water. Get medical attention if irritation develops.
Inhalation: Not relevant.
Ingestion: Do NOT induce vomiting. Do NOT administer anything by mouth to unconscious person. Offer water to drink. Get medical attention.
Note to Physicians: Not relevant.
SECTION 5: FIRE FIGHTING MEASURES
Suitable Extinguishing Media: Foam, powder, water spray Unsuitable Extinguishing Media: Water stream Products of Combustion: Not applicable Specific firefighting methods: No specific methods required Specific protective devices: Self-contained breathing apparatus Specific hazards: No specific hazards known
Protection of Firefighters: Firefighters should wear self-contained breathing apparatus and full fire-fighting turnout gear.
SECTION 6: ACCIDENTAL RELEASE MEASURES
Personal precautionary measures: No special measures required.
Environmental precautionary measures: Observe usual precautions.
Methods for cleaning up: Collect mechanically.
Other Information: Spills of this material do not need to be reported to the National
Response Center.
SECTION 7: HANDLING AND STORAGE
Handling
Keep away from heat, sparks and flame - do not smoke - Do not get in eyes. Do not breathe vapor. Avoid prolonged contact with skin.
Version March 2020 Page 3 of 5 Safety Data Sheet AQUAPHALT 0/4.0, 0/6.0, 0/9.0, 0/12.0, AQUAPHALT SAFETY DATA SHEET, Rev. Date: Mar 2020Page 3 of 5
Storage
Requirements on storage rooms and containers: Store in weather / sun protected area! Keep container well closed, material cures by exposure to air. Product residue may remain in empty containers. Observe all label precautions until container is cleaned, reconditioned or destroyed.
Information about storage in a common storage facility: Not relevant Further information about storage conditions: Store in weather / sun protected area Storage class according to VCI: Not relevant.
Appropriate application(s): For patching up asphalt and concrete
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Guidelines Component 1: Not established.
Component 2: Not established.
Engineering measures: No special requirement.
Components with critical values that require inspection at the place of work: The product does not contain any relevant quantities of material with critical values, which have to be monitored at a work place.
Eye/face protection: Not required
Skin protection: Wear suitable work gloves.
Respiratory protection: Not required
General Hygiene Considerations: Wash thoroughly after handling. Have eye-wash facilities immediately available. Do not eat, drink and smoke while working.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Appearance: black, solid Odor: characteristic Odor threshold: Not available Physical state: mineral – binder - mix pH - value: not relevant Freezing point: not relevant Boiling point: not relevant Flash point: not relevant Flammability: not relevant Upper Flammability Limit: not relevant Lower Flammability Limit: not relevant Vapor pressure at 20 °C/68 °F [mmHg]: not relevant Vapor Density at 25° C [g/ cm3]: 2-2.5 Solubility in water at 20°C/68 °F: not relevant Solubility in fat at 20 °C°C/68 °F: not relevant Auto-ignition Temperature: Not available.
Dynamic viscosity at 20° C°C/68 °F [mPas]: not relevant Percent Volatile, wt. %: _0_ Volatile Organic Compound (VOC) content, wt. %: _0_ Fire promoting properties [°C]: product is not oxidizing Danger of explosion [°C]: product is not explosive
Version March 2020 Page 4 of 5 Safety Data Sheet AQUAPHALT 0/4.0, 0/6.0, 0/9.0, 0/12.0, AQUAPHALT SAFETY DATA SHEET, Rev. Date: Mar 2020Page 4 of 5
SECTION 10: STABILITY AND REACTIVITY
Stability: Stable.
Conditions to avoid: Keep away from heat, sparks and flames.
Incompatible Materials: not relevant Possibility of Hazardous Reactions: Will not occur.
Hazardous Decomposition Products: Not relevant
SECTION 11: TOXICOLOGICAL INFORMATION
No adverse effects are expected if this product is handled in accordance with this Safety Data Sheet and the product label. Symptoms or effects that arise when the product is mishandled or overexposure occurs are:
ACUTE EFFECTS:
The product is classified as not acute toxic.
CHRONIC EFFECTS: *
The product is classified as not sub-acute respectively chronically toxic.
Corrosive or irritant effect or sensitization:
The product is classified as not irritating or sensitizing.
Likely Routes of Exposure: Eye contact, skin contact.
Eye: Causes mild/moderate irritation (tears, blurred vision and redness).
Skin: Prolonged exposure may cause moderate skin irritation. May cause drying/defatting of the skin.
Ingestion: Not likely to be toxic but may cause irritation of the mouth, throat and stomach.
Inhalation: Not relevant
Medical Conditions Aggravated By Exposure:
May cause more significant skin irritation in people with pre-existing skin conditions.
SECTION 12: ECOLOGICAL INFORMATION
Mobility in Environment: Not relevant.
Persistence/ Degradability: Not relevant.
Bioaccumulation/ Accumulation: Not relevant.
Further negative effects: There are no negative effects known.
SECTION 13: DISPOSAL CONSIDERATIONS
Disposal: Dispose of in accordance with federal, state and local regulations. * Packaging: Packaging can be reused or recycled after cleaning. Note local restrictions. *
SECTION 14: TRANSPORT INFORMATION
UN number Not applicable UN Proper shipping name Not applicable Transport Hazard class(es) Not applicable Packing group, if applicable Not applicable Marine pollutant (Y/N) Not available Special precautions: Not available
Version March 2020 Page 5 of 5 Safety Data Sheet AQUAPHALT 0/4.0, 0/6.0, 0/9.0, 0/12.0, AQUAPHALT SAFETY DATA SHEET, Rev. Date: Mar 2020Page 5 of 5
US DOT (ground) Proper Shipping Description: This product is not regulated for shipping by US DOT.
Canadian TDG (ground) Proper Shipping Description: See US DOT
ICAO (air) Proper Shipping Description: See US DOT
IMDG (water)
Proper Shipping Description: See US DOT
ADR/ RID
Proper Shipping Description: See US DOT
ADN/ ADNR
Proper Shipping Description: See US DOT
SECTION 15: REGULATORY INFORMATION
OSHA PROCESS SAFETY (29CFR1910.119): Not regulated.
Inventory Status United States (TSCA): All ingredients are on the inventory or exempt from listing.
SECTION 16: OTHER INFORMATION
NFPA 704: National Fire Protection Association Health – 0 Fire –0 Reactivity –1 0 = minimal hazard, 1 = slight hazard, 2 = moderate hazard, 3 = severe hazard, 4 = extreme hazard
The above SDS complies with OSHA hazard communication standard 29 CFR 1910.1200(g), as revised in 2012.
To the best of our belief, information and knowledge, we believe the information contained in this MSDS to be accurate and reliable as of the date of this Material Safety Data Sheet. The above information is based on information received from raw material suppliers and other sources and references the products as currently formulated. We make no expressed or implied warranty regarding the accuracy or reliability of the data or results obtained from the use of the product and assume no responsibility or liability for personal injury or property damage incurred by the use of these materials due to the fact that the conditions of handling, use, and storage of these materials are beyond our control. Any and all materials should be used with caution and may present unknown hazards. The information and recommendations in this material safety data sheet are offered for the users' consideration and examination. It is each user’s responsibility to determine if the information and data contained herein is suitable and to comply with all applicable international, federal, state, and local laws and regulations.
Modifications compared to a prior version are marked with the star symbol * on the right margin.
Prepared by Reactive Asphalt Distribution LLC (revised by OHK Environmental Consulting, LLC, March 2020)
File details come from the government source that posted it. Updated .