Plug, centering bearing

Added: Jun 21, 2017 10:09 am ITEM DESCRIPTION:

PLUG, CENTERING BEARING. CONSISTS OF 2

RP001: DLA PACKAGING REQUIREMENTS FOR PROCUREMENT

RA001: THIS DOCUMENT INCORPORATES TECHNICAL AND/OR QUALITY REQUIREMENTS
(IDENTIFIED BY AN 'R' OR AN 'I' NUMBER) SET FORTH IN FULL TEXT IN THE
DLA MASTER LIST OF TECHNICAL AND QUALITY REQUIREMENTS FOUND ON THE WEB
AT: http://www.dla.mil/HQ/Acquisition/Offers/eProcurement.aspx. FOR
SIMPLIFIED ACQUISITIONS, THE REVISION OF THE MASTER IN EFFECT ON THE
SOLICITATION ISSUE DATE OR THE AWARD DATE CONTROLS. FOR LARGE
ACQUISITIONS, THE REVISION OF THE MASTER IN EFFECT ON THE RFP ISSUE DATE
APPLIES UNLESS A SOLICITATION AMENDMENT INCORPORATES A FOLLOW-ON
REVISION, IN WHICH CASE THE AMENDMENT DATE CONTROLS.

RQ011: REMOVAL OF GOVERNMENT IDENTIFICATION FROM NON-ACCEPTED SUPPLIES
BUSHINGS, 1 PLUG, 1 ABRASION STRIP AND ADHESIVE.
2.900 INCH OVERALL LENGTH BY 1.960 INCH OVERALL
WIDTH. 4 HOLES IN CORNERS OF PIECE, 1.250 INCH
DIAMETER HOLE IN PIECE.
ADEQUATE DATA FOR THE EVALUATION OF ALTERNATE
OFFERS IS NOT AVAILABLE AT THE PROCUREMENT
AGENCY.THE OFFEROR MUST PROVIDE A COMPLETE
DATA PACKAGE INCLUDING DATA FOR THE APPROVED
AND ALTERNATE PART FOR EVALUATION.
CRITICAL APPLICATION ITEM

SEANAIR MACHINE CO. INC. 63630 P/N 70105-28034-041
SIKORSKY AIRCRAFT CORPORATION DBA 78286 P/N 70105-28034-041

SHALL BE PACKAGED IN ACCORDANCE WITH ASTM D 3951.
When ASTM D3951, Commercial Packaging is specified, the following apply:
•,,All Section "D" Packaging and Marking Clauses take precedence over
ASTM D3951.
•,,In addition to requirements in MIL-STD-129, when Commercial Packaging
is used, the Method of Preservation for all MIL-STD-129 marking and labeling shall be "CP" Commercial Pack.
•,,The Unit of Issue (U/I) and Quantity per Unit Pack (QUP) as specified
in the contract take precedence over QUP in ASTM D3951.