Crane & Power Installation at Bldg. 125

A. General.
1. The contractor shall coordinate with WVA for any additional assistance after delivery of upgrade material.

B. Reinstall/Install cranes and power conductors in Bldg. 125
Contractor will:
1. Install eight (8) overhead cranes in selected bays, (WVA to identify which cranes go in applicable bays).
2. Install hoists on proper cranes.
3. Reinstall buss bar in three of the four bays (bar to be provided by Watervliet Arsenal), connect to existing power leads.
4. Provide and Install approximately 125' of 90 amp 4 conductor Safe-Lec bar in 1st bay (furthest East). One (1) bar to be green in color for ground. Connect new conductor to disconnect (WVA to identify location of disconnect).
5. Connect crane power to reinstalled/installed buss bar.
6. Fabricate and install new end stops with rubber bumpers in bays where needed.
7. Change four (4) pendants and pendant cables with new pendants (WVA will identify pendants and cable to be replaced)
8. Supply two (2) spare pendant controls
9. Supply spare drive for bridge motion.
10. Test all cranes for proper operation, identify malfunctions.
11. Perform crane load tests with WVA personnel.
12. Work to be completed no later than 4 weeks from time of contract award.

.