RFI_1.docx

RFI #1

1. Can you please advise us the preferred manufacturer for this product or additional information to get pricing for the same?

There’s no preferred manufacturer, however, 52’’ x 50’’ FiberCELL Kern Laser Systems (Class 1) meets all of our requirements. We are looking for something equal or better.

2. What power of the laser and footprint machine size you prefer? The power should be 1.0kW Ytterbium and the foot print should be 115” W x 114” L x 77 H” in the fully extended configuration but when broken down it need to be able to fit through a 70 ¾ inch door opening.

3. Is the contractor responsible for only transportation? Just transportation

4. Responsible for transportation, offloading and setting the machine in place in the facility? Just transportation, we can off load it, move it in place and wire it.

5. What if any reference is there for the crating specification? The contractor will be required to get the laser to us without it getting damaged in shipment.

6. Is the contractor responsible for disposal of dunnage? No

7. Is the contractor responsible for anchoring the machine to the floor? No

8. Is the contractor responsible for electrical supply in the facility, conduit/ wire/ disconnect, etc.? No, we have a state electrician on staff that will take care of it for us.

9. Is a special government specified nomenclature serial number tag required? No

10. How many hours/ days of training is required? 2 Days/16 Hours

11. Confirming an IUID tag is required? It is not required.

12. I noticed the spec called for dual sliding doors. Our machine has a rear access door. Is this acceptable and if not can you explain why you need dual sliding doors? That is acceptable.

13. Also, the spec does not mention table size, please let us know what size table is required in the machine? 52” x 50” working area.

14. What’s the max sheet size? 52” x 50”