Purchase_Requirement.pdf

R&R

Aqueous Parts Washer Purchase

PURPOSE

Purchasing an aqueous parts washer

Discussion The 115 Repair and Reclamation Shop (R&R) is looking to replace the current solvent tank parts washer. The current parts washer requires manual cleaning by hand and uses a harsh solvent (PD-680) that requires multiple layers of PPE and gives off a noxious odor. An aqueous parts washer cleans the parts like a dish washer, uses a water soluble cleaner and uses power jets in an enclosed housing reducing exposure to chemicals and vapors and greatly reducing man hours cleaning wheels and parts.

• 1 Each Aqueous Parts Cleaner Key Features

– Washer cannot be bigger than 45”W x 62”Deep x 69”H

– Washer inside working area cannot be any smaller 36”H

– Turntable diameter 30”

– Stainless Steel

– Minimum 750 lbs turntable capacity

– 230V 3-Phase power

– 75GPM @ 60 PSI pump motor output

– Motorized wheel controlled oil skimmer

– Fixed turntable that does not require to be pulled out to access

– Top, bottom and side stainless steel spray nozzles

– Retractable middle stainless steel manifold for small parts

– Gasketed door to seal-in steam and minimize exhaust requirements

– Re-circulated rinse system

– Low water shut-down and automatic water fill

– Locking door switch activated during cycle

– Hi-temp plastic slip for rim to sit on