Smartracker_Installation_Checklist.pdf

SMARTRACKER™

Prerequisites for Installation

InstroTek, Inc. 1 Triangle Drive, Research Triangle Park, NC 27709 phone: 919.875.8371 email: sales@instrotek.com web: www.instrotek.com

DIMENSIONS & TRAINING TIMES POWER REQUIREMENTS & PLUG

Footprint: 48 L X 54 W X 50 H inches Shipping Dims: 64 L x 64 W x 65 H inches Shipping Weight: 1650 lbs.

Minimum space around unit: 18 inches behind the device (24 inches is recommended to allow easy access to the water ports); 18 inches to the left side of the device and 24 inches to the right side (controller side) of the device.

Door opening— If applicable, a door opening of at least 44" must be available for the SmarTracker to move through.

Please allow one full day of training. Training consists of reviewing the equipment software and operations (sample prep), and suggested schedule of cleaning and

PM. Setup, verifi cation, and confi guration will take 2 to 4 hours prior to training.

Dedicated 230VAC/60Hz single phase circuit with a minimum capacity of 30 amps is recommended. All electrical circuits, hardware and components should be specifi ed by a licensed electrician prior to the installation.

WATER SUPPLY & DRAIN

Supply: Hot water supply is necessary (30-50 gallon water heater set to 115°F has been shown to be effective). A hot water supply will decrease the initial time to heat the water to the testing temperature by up to 4 hours (contact InstroTek for additional options if you are unable to have a hot water supply). The SmarTracker water inlet is fi tted with a standard 3/4" female garden hose connection. It is recommended that the system is connected with a fl exible water line to the building hot water supply. An in-line shutoff valve is recommended on the hot water supply line, but it is not required to operate the SmarTracker.

Drain: A fl oor drain is preferred, but not required. The system can also be connected to an in-house system drain, assuming the drain is below the HWT tank level. At a minimum, a 5-gallon bucket can be used to drain the tank into a sink. The system has three drains (two top tanks and a single bottom tank), these have 3/4" garden hose connections.

HAMBURG WHEEL

TRACKER

MANDATORY FOR TRAINING

Four gyratory compacted asphalt samples - 150 mm in diameter and 62-63 mm in height - to allow our technician to demonstrate cutting of samples and proper operation of the SmarTracker. A method to cut the sample, such as a wet saw, is necessary for the technician to demonstrate proper sample preparation.

phone: 919.875.8371 email: sales@instrotek.com web: www.instrotek.com sink. The system has three drains (two top tanks and a single bottom tank), these have 3/4" garden hose

HAMBURG WHEEL

TRACKER

Four gyratory compacted asphalt samples - 150 mm in diameter and 62-63 mm in height - to allow our technician to demonstrate cutting of samples and proper operation of the SmarTracker. A method to cut the sample, such as a wet saw, is

Contact a licensed electrician!