CID_A-A-59932_Rev_1.pdf

CID A-A-59932

18 July 2016

Commercial Item Description (CID)

TACTICAL VEHICLE, ARMORED

Continuation Sheet

Revision 1

18 July 2016

AFLCMC/WNZ

Robins AFB GA

The following part of CID A-A-59932 is revised as indicated below:

1. Was:

2.4 Weight and dimensions. Overall weight and dimensions (see 2.5.2) shall not exceed Table II:

Change To:

2.4 Weight and dimensions. Overall weight and dimensions (see 2.5.2) shall not exceed Table II

(note that height does not include the roof mounted turret):

2. Add:

2.4.3 Power inverter/battery charger. The vehicle shall have an AC-DC power inverter with a battery charger permanently mounted on the vehicle in a properly ventilated, accessible location.

3. Was:

2.11 Vehicle cabin. The vehicle shall have a cabin capable of seating four 95th percentile males in individual seats, each with individual weapon racks capable of holding a standard M4 carbine.

2.11 Vehicle cabin. The vehicle shall have a fully enclosed, four-door cabin, plus a rear troop door, capable of seating four 95th percentile males in individual seats. The vehicle shall have windows at each crew member location. The windows shall provide a similar level of ballistic protection as the body of the vehicle. Each of the seat locations shall be equipped with individual weapon racks capable of holding a standard M4 carbine. The driver's seat shall be of an adjustable design. Each seat shall be provided with a Type 2 seat belt assembly (i.e., 3-point restraint) in accordance with 49 CFR 571.209.

4. Add:

2.11.3 Windshield. The vehicle shall be equipped with a heated windshield that shall provide a similar level of ballistic protection as the body of the vehicle.

5. Add:

2.11.4 Heated mirrors. The mirrors shall be of the motorized remote control type, providing not less than 60° horizontal rotational viewing range. The flat mirrors shall also have electrically heated heads. Mirror remote and heating controls shall be conveniently located inside the cab within reach of the seated driver.

6. Add:

2.14.1 Spotlights. Two 160,000 candlepower LED type spotlights shall be attached to the roof of the vehicle. The spotlights shall be capable of being operated remotely and providing illumination on all sides of the vehicle.

7. Was:

4.5.8 Mobility tests.

i. Turning diameter. A first production vehicle shall be tested in accordance with SAE

J695 in both directions to measure its wall-to-wall 50-feet turning diameter.

4.5.8 Mobility tests.

i. Turning diameter. A first production vehicle shall be tested in accordance with SAE

J695 in both directions to measure its wall-to-wall 60-feet turning diameter.